Use and Care Manual

13
DISPENSING COFFEE
Operating Instructions:
1. Make sure you have turned on RED hot water switch at the back. See No. 15 on page 13.
2.
3.
4.
Touch “PRE-HEAT” button. If “READY”
light is not ON.
a. Open lid and place a COFFEE
CAPSULE when “ ” LED is
flashing.
b. Press coffee capsule down by
your hand to pierce bottom of the
capsule.
c. If Brewer was switched off, wait up to 10 minutes until the Ready light is
ON. If “READY” light is flashing, it indicates there is not enough water in
storage tank. Wait until water is pumped up. Check if bottle has water.
Ready light will go on only when hot water tempera-
ture is 201°F. Water temperature goes down to 176°F
if Brewer was not used for 3 hours. Ready light might
keep on flashing if water level is low. Please check the
bottle.
5.
By default 8 oz, middle cup is pre selected
for you. If you wish to have different size cup,
touch your choice of 4, 6, 8, 10and 12 oz.
6.
Place a coffee cup on top
of brewers drip tray.
DO NOT OPEN LID when “ ” RED light is on
START
INFU-
SION
READY
PRE-
HEAT/
INFU-
SION
START
READY
PRE-
HEAT/
INFU-
SION
START
READY
PRE-
HEAT/
INFU-
SION
START
READY
PRE-
HEAT/
INFU-
SION
START
READY
PRE-
HEAT/