Manualshelf

Use and Care Manual

ManualsBrandsWhirlpool ManualsKitchenSingle Cup Coffee Maker and Self-Cleaning Water Cooler in Stainless Steel
11121314151617181920
Dispense Hot Water
This unit dispenses water at temperatures that can severe burns. Avoid direct contact with hot
water. Keep small children and pets away from unit while dispensing. Never allow small
children to dispense hot water without proper and direct supervision.
Note: After setup, hot water will be available in 15-20 minutes.
1. Position suitabe cup securely below hot water tap.
a. The left arrow below the hot water control indicates the location of the hot water tap.
b. The target holes in the grill help align the flow of water. This unit dispenses water at a fast rate. To
avoid splashes, hold cup as close to the tap as possible.
2. Push hot water release button (red) inward and depress control downward to start flow.
CAUTION
HOT WATER
Notice:
At initial start-up it will take about 3 minutes for the reservoirs to fill.
If the lights continue to flash, your bottle may be empty. If problems persist, Call 1-844-378-7288 for
assistance.
Initial Rinsing of Water Lines
This unit has been tested and sanitized prior to packing and shipping. However, during transit odors
from shipping containers can accumulate in the tank and lines. To remedy, please follow the instruc-
tions below.
1. Allow cooler to fill with water as per initial setup instructions.
2. Plug unit in turn hot water switch ON.
3. Wait for 30 minutes.
4. Drain unit completely using drain plug at the back.
Be carefue, water is hot.
Dispense Cold Water
Note: After setup, the cooler will take up to 1 hour to get water to cold
temperature. During this time the compressor may run continuously. This
is normal.
1. Position bottle, glass, pitcher or cooking pot securely below cold water
tap.
a. The right arrow below the cold water control indicates the location of
the cold water tap.
b. The target holes in the grill help align the flow of water. This unit
dispenses water at a fast rate. To avoid splashes, hold cup as close
to the tap as possible.
2. Depress right control downward to start flow.
3. Release control once desired fill level is achieved.
17