Use and Care Manual

WARNING

Blockage of passageways

When brewer is operated properly, it will not get blocked. If same coffee capsule is used more than

once it may create blockage. To prevent passageway blockage please use coffee capsule once only.

Open lid few seconds after last drop had run out. Do not open lid prematurely. Coffee cartridge with

piercing needle must be maintained clean and without the dirt. Container below the cartridge must be

periodically cleaned from dried up coffee.

Your Brewer has two capsule piercing needles. One on top, called inlet needle and one at the

bottom, called outlet needle. It also has long passageway from the brewer to the exit nozzle. If block-

age occurs in the exit nozzle, use unfolded paper clip to clean it out. To maintain proper operation

make sure the both needles and exit nozzle are kept clean.

Lower needle is not of tubular construction and does not go all the way through. It has U-shaped

configuration with slot on its side. This proprietary design makes clogging up this needle more difficult

compared to conventional design. If lower needle is blocked, wash cartridge under running water and

use unfolded paper clip to clean inside of the needle. It is not open all the way through. It has sealed

end.

Coffee runs out of the coffee capsule through the slot in the needle and then into the inside of the

coffee capsule using same slot. This way blockages are minimized and coffee runs out of the machine

at lower temperature. During the brew process water is very hot.

If upper, inlet nozzle get blocked use paper clip to clean. Needle has 3 openings around the central

spike. Check if the silicone seal on the upper piercing needle is properly installed.

Dispense few cups of water to rinse well. Clean with unfolded paper clip well. To dispense water

only you will need to open and close lid in order to send signal via sensor to control board. Never leave

blocked needle for more then 5 minutes, since blocked coffee will dry up and make it more difficult to

remove.

Use paper clip to clean dispensing

nozzle nozzle as shown.

Be careful not to enter paper clip too deep in to passageway. It is not straight and

food grade silicone tube can be damaged.

Call service center 1-844-378-7288 for an assistance. Pneumatic pump will be

shipped to you for cleaning the blockage.