Use and Care Manual

7
SOUND’S YOU MIGHT HEAR
Although all functions are very quiet, you might hear following sound’s:
1. When without display cooler plugged in, air pump for an ozone start to work and last for 12 seconds.
After start up it will work every 4 hours for same period of time.
Coolers with display are programmed to have ozone delivery pump to work every 4 hours starting
from 12 o’clock. Very low humming sound.
2. Water Filtration system delivers water to cold tank. Running water into cold tank can be heard also,
like a miniature water fall, or a fish aquarium. Very low sound.
Water pump sound is greater when filter is used, due to the added load.
If you need assistance call 1-844-378-7288.
There are two water level control devices. An Electronic sensor and mechanical float valve.
Electronic sensor activates solenoid shut off valve silently.
Mechanical float valve is similar to toilet bowl float valve. As water level nearing to be full, near
closing the valve higher pitch noise might be heard from the float valve.
This noise will last until cold water tank is full.
3. Hot tank water heater.
During the periods of maintaining steady temperature hot tank operates in silent mode.
When water is dispensed or pre-heat button is activated Turbo function will emit “kettle” like
moderate sound few minutes before it reaches the required temperature.
4. Refrigeration compressor works when water needs to be cooled. It has very low pitch humming
noise like your refrigerator
5. In some cases sound resulting from installation on hard flooring is present. Place Sound absorbing
mat under your cooler to eliminate this noise. Mat is supplied with your cooler.
ATTENTION
To avoid damage, malfunctioning and plugging up top piercing needle.
Do Not Use same K-Cup or an equivalently packed Single Serve Coffee Cup twice, do not use
Espresso cups, use only K-Cup or an equivalently packed Single Serve Coffee Cups made for drip
coffee use only.
If flow and amount of dispensed water deteriorates, use paper clip to clean top piercing needle, as
described in the manual. To wash the brewing pot dispense hot water without placing K-cup or
equivalent Single Serve Coffee Cup.
It is recommended to use purified water made by Reverse Osmosis, or Distilled, without mineralization.
This way internal valves and hot tank will not clog up with calcium deposits and help to keep your
machine trouble free without any need for descaling.
Please place water bottle and plug power cord into electrical outlet.
Wait until water is fully filled. Check for hot water faucet dispensing water.
Turn hot tank power switch on.
To fill bottle door must close and activate door switch.
If door got distorted during shipping, please twist it back into position.