Use and Care Manual

OPERATION
This unit is intended for water dispensing only. Do NOT use other liquids. Do NOT use
for other purposes. Warranty is void if used with any other liquids such as coffee, tea,
juices, beer or wine.
This dispenser has been designed to use water bottles with a 3 or 5 gallon capacity. Do
NOT use alternative bottles.
Initial Set Up
Note: To avoid damage to the compressor, allow the unit to sit upright for at least 4 hours prior
to operation.
1. Remove the tamper seal from the bottle cap. Do NOT remove the plastic cap.
2. Clean the bottle cap and neck using a soft cloth and warm soapy water, then rinse after-
wards.
3. Lift the bottle and insert onto the probe. Apply slight pressure until the plug inside the cap
pushes in and the bottle is seated. Water will begin to flow into the reservoirs, causing air
bubbles to form in the bottle.
4. Plug the cord into a properly grounded wall outlet.
IMPORTANT
Model # 7LIECK-W-WL: Page 10
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-5-WHIRL-5 for assistance.
Electrical shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
WARNING
Excessive Weight Hazard
Use two or more people to move and install the
water cooler and the bottles.
Failure to do so can result in back or other injury.
WARNING