Use and Care Manual
Model # 7LIECK-W-WL: Page 7
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-5-WHIRL-5 for assistance.
4. Install the Wall Mount Strap to prevent accidental tip
over:
• Unclip the strap from the back of dispenser.
• Mount the strap 25 inches up from the floor directlyto
the wall stud with a screw (see Illustration A).
If the stud is not available, insert and turn the anchor
directly into the sheet rock using a star shaped
screwdriver (DO NOT drill a hole into the sheet rock
first when using this anchor). Secure the strap by
installing a screw through the washer, then the eyelet
into the strap, and into the wall mounted anchor (see
Illustration B).
• Position the cooler in place.
• Clip the strap onto the back of the cooler to either the
right or left side (see Illustration C).
• Adjust the length of the strap.
Note: The dispenser can be positioned in a corner but it
still requires the Wall Mount Strap to be installed.
Adjust length of the wall strap accordingly.