Use and Care Manual

CLEANING PRIOR TO INITIAL USE
To remove any odors or dust that may have accumulated during shipment, you may want
to clean the dispenser prior to first use.
DO NOT PLUG THE COOLER INTO AN ELECTRICAL POWER OUTLET AT THIS TIME.
Time Required for Set Up: 40 minutes.
1. Remove the bottle receptacle by turning it counterclockwise and
pulling up.
2. Remove the plastic baffle from inside the reservoir. Clean with
warm soapy water, rinse.
3. Fill the reservoir with a mixture of 1 gallon tap water and 1
teaspoon or unscented bleach (5.25% sodium hypochlorite).
4. Let sit for 30 minutes.
5. Remove the cleaning mixture from the reservoirs by dispensing the mixture from both taps
into a pitcher.
6. Wipe the inside of the reservoir with a soft cloth.
7. Fill the reservoir with 1 gallon tap water.
8. Remove the water from the reservoir by dispensing it from both taps into a pitcher.
9. Reattach bottle receptacle to this unit.
10. Complete the installation and follow the operation instructions indicated in this manual.
11. Repeat rinsing cycle if chlorine taste persist.
If your water has an off-taste, do not return the dispenser to the store. Call 1-855-5-
WHIRL-5 for assistance.
Model # 7LIECK-W-WL: Page 8
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-5-WHIRL-5 for assistance.
To Remove Bottle
Receptacle