Instructions / Assembly

Electrical shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
serious injury, fire, or electrical shock.
WARNING
Step D: Rinse Reservoirs
1. Dispose of the water and bleach mixture and rinse the bottle with tap water.
2. Fill the bottle with tap water and insert the probe into the bottle.
3. Push the probe down until it is seated.
4. Slide the bottle into the cabinet and close the door.
5. Plug the power cord into a grounded wall outlet.
6. Turn the energy saving switches ON.
7. Allow the water to fill up the empty reservoirs.
8. Wait 10 minutes then turn the energy saving switches OFF and unplug the power cord.
9. Place a 2 gallon or larger bucket under the drain plug in the rear of the dispenser.
10. Remove the drain cap and the drain plug. Cold water will immediately flow into the bucket.
After several seconds, hot water will dispense.
Reminder - Place the drain cap and the drain plug in a safe location so that they will not be
lost.
11. Once the unit has been drained, replace the drain plug and the drain cap.
12. Remove the remaining water from the reservoir by dispensing from the cold tap into a pitcher.
13. Return the unit to its location, install a fresh water bottle, plug the power cord back into the
grounded wall outlet and turn the energy saving switches ON.
Model # 8LIECHK-SSF-WL: Page 13
Excessive Weight Hazard
Use two or more people to move and install bottles.
Failure to do so can result in back or other injury.
WARNING
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.