GB CONTENTS BEFORE USING THE DISHWASHER PAGE 11 PROTECTING THE ENVIRONMENT PAGE 11 PRECAUTIONS AND GENERAL RECOMMENDATIONS PAGE 11 CONNECTIONS PAGE 12 ELECTRICAL CONNECTION PAGE 13 HOW TO FILL THE SALT CONTAINER PAGE 14 HOW TO FILL THE RINSE AID DISPENSER PAGE 15 HOW TO FILL THE DETERGENT DISPENSER PAGE 16 CARE AND MAINTENANCE PAGE 17 To make the most of your new dishwasher, please read these user instructions and the quick reference guide carefully.
BEFORE USING THE DISHWASHER 1. • Removing the packaging and check After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer. Keep the packaging materials (plastic bags, etc.) out of children's reach, as they are potentially dangerous. 2.
CONNECTIONS Do not use the dishwasher if it has been damaged in transit. Consult our After-Sales Service or your local retailer. (Refer to the separate assembly instructions booklet) Water inlet and drain: • Observe any special regulations issued by your local Water Board. • Make sure the inlet and drain hoses are kinkfree and are not crushed. • If the hose length is not sufficient, please contact your local dealer or our After-Sales Service.
ELECTRICAL CONNECTION For Great Britain Only The wires in the mains lead are coloured in accordance with the following code: BLUE - “NEUTRAL” (“N”) BROWN- “LIVE” (“L”) GREEN AND YELLOW - “EARTH” (“E”) 1. The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter “E” or by the Earth symbol yellow. or coloured green or green and 2. The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured black. 3.
HOW TO FILL THE SALT CONTAINER To ensure the dishwasher works at its best, soft water, i.e. water that is lime-free, is required. The presence of lime in tap water causes water stains due to calcium deposits on crockery and glasses. A water softening system has been built in the dishwasher to ensure a steady supply of soft water. This is basically a decalcifying system, which needs to be regenerated regularly using special dishwasher salt.
HOW TO FILL THE RINSE AID DISPENSER The rinse aid is used to reduce the surface tension of the water droplets remaining on your crockery after the wash, causing the water to flow down easily, thus preventing the formation of water streaks or stains. It also helps reduce drying time. Before using the dishwasher for the first time, fill the rinse aid dispenser. Only use rinse aids recommended for use in domestic dishwashers How to fill the rinse aid dispenser: 1.
HOW TO FILL THE DETERGENT DISPENSER A small compartment (A) and a large one (B) are provided for the detergent. The use of detergent in excess of the recommended dosage may cause pollution. The recommended dosage varies for different brands. If you use detergents in tablet form, follow the manufacturer's directions for use. The detergents in common use either contain phosphates or are phosphate-free. Both can be used with the dishwasher.
CARE AND MAINTENANCE Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap. Cleaning the outside of the appliance: To clean the outside of the appliance, use a neutral detergent and a damp cloth. To clean the control panel, use only a slightly damp cloth. Do not use abrasive detergents. Cleaning the inside of the dishwasher: Regularly wipe the door seal and inside of the door with a damp cloth to remove any food residue.
