Quick Start Guide

ManualsBrandsWhirlpool ManualsDishwasherADP 5654 WHM

Whirlpool is a registered trademark of Whirlpool USA

5019 396 91299

ADP 5654

Quick Reference Guide

Before using the dishwasher, read the user instructions!

WH/I/K/GB

(We reserve the right to make technical modifications)

Add rinse aid

Add regeneration salt

Only add regeneration salt immediately

before starting a wash programme.

“Half load - Multizone” button

Load the upper or lower rack only.

This function can be used with any programme.

Press once = upper rack (the indicator lamp comes on)

Press twice = lower rack (the indicator lamp comes on)

Press 3 times = Off (half load function deactivated).

1) Reference programme for energy label in compliance with

EN 50242 regulations;

2) Refer to “User instructions“;

3) Program data obtained in conformity with European standard

EN 50242. Values may vary in relation to usage, e.g.:

different loads, water temperatures - above or below 15°C -

as well as water hardness and power supply voltage, etc.

Program selector knob

Mains

On / Off

Start button

Switches “on” when the dishwasher is

operating. Flashes when a fault occurs.

Switches off at the end of the programme.

Indicators

Options

Programme chart

Detergent

Consumption

Programmes Loading instructions A B Litres kWh Minutes

Pre-Rinse cold

Crockery to be washed later. - - 7.0 0.03 14

Quickwash 40°C

Lightly soiled crockery with no dried-on

food.

X - 13.0 0.65 30

Eco 50°C

Normally soiled crockery. X - 13.0 1.30 75

Normal

50°C

Normally soiled crockery. X X 16.0 1.24 128

Normal 65°C

Normally or heavily soiled crockery. X X 16.0 1.45 90

Intensive 70°C

Recommended programme for heavily

soiled crockery, especially suitable for

pans and saucepans.

X X 17.0 1.70 140

Important information for Test Laboratories:

For detailed information on the EN comparison test and other tests, contact the following address:

“nk_customer@email.whirlpool.com”.

Summary of content (4 pages)

PAGE 1
Before using the dishwasher, read the user instructions! GB Quick Reference Guide ADP 5654 Options Program selector knob Mains On / Off Start button “Half load - Multizone” button Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme. Load the upper or lower rack only. This function can be used with any programme.
PAGE 2
How to use the appliance Further indications are given in the single chapters and in the user instructions. Switch on the appliance Automatic start by turning the programme selector knob (in case of retractable knob, first press the knob to access it). Large compartment A: How to fill the detergent dispenser A With each wash cycle. B C Small compartment B: For programmes with pre-wash only. Check the rinse aid level Check the regeneration salt level Load the racks Mechanical indicator C.
PAGE 3
Dishwasher loading instructions and racks provided Upper rack: depending on the model Multi-purpose support (A): 1) Depending on the position, for long-handles utensils, cups and glasses. May be used in three different positions. Crockery holders (B): Depending on the position, for example plates, cups and long-stemmed glasses. Revolving glass support (C): 2) Depending on the position, for example small or long-stemmed glasses. Half Load: Load the upper rack only.
PAGE 4
What to do if... If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working If crockery is not perfectly dry If crockery is not perfectly clean Cause Remedy • No water supply. • Open the tap. • The appliance does not load sufficient water. • There is a power failure. • Starting the selected programme.