Operation Manual

N C
M Y
INSTALLATION
x Do not install the freezer close to any heat
source.
x Place it in a dry and well ventilated space.
x Make sure that the appliance is well levelled
andadjusttherearfeet,ifnecessary.
x Never cover the plinth. You must leave at
least a 50 mm gap, if the appliance is installed
under a kitchen furniture.
x Fit the shelves inside the appliance.
x Let the appliance stand for 1 hour prior to
connecting it to the electricity supply.
Electrical connection
x Check that the voltage on the rating plate
corresponds to the voltage in your home.
x The earthing of the freezer is compulsory
by law.
The Manufacturer will accept no liability
for damage to persons or to objects
arising from the non-observance of this
requirement.
x If the plug and the wall socket do not comply,
have the socket replaced by a qualified
technician.
x Do not use adapters, multipole sockets or
extension cords.
Door reversibility
X
1. Remove the plinth unscrewing 6 screws and
the electrical housing unscrewing 2 screws.
2. Tilt the appliance backwards and remove the
lower right hinge.
X
3. Remove the door from the pin of the top
hinge.
4. Remove the screw cover, the screws and the
top right hinge.
5. Remove the 3 clips covering the holes of the
left screws.
6. Fix the hinge to the top left hand side, using
thesamescrewstotightenit.
7. Reposition the clips and the screws cover in
the relevant holes.
8. Fit the door in the pin of the top hinge.
X
9. Mount the lower hinge on the left hand side
in the holes already provided on the
appliance.
10. Retighten the plinth and the electrical housing
into position.
X
1
X
3
X
9
14
14