3gb54361.
3gb54361.fm5 Page 18 Thursday, May 9, 2002 6:01 PM INSTALLATION Technical information for the installer Oven After removing the oven from its packaging, before making the connections place it on the polystyrene foam base to protect it from damage. Do not attempt to lift the oven by the handle. Lift at the sides as shown in the figure (see arrow). Check that the appliance has not been damaged in transit. Oven dimensions and kitchen unit dimensions are shown in the opposite figure.
gb54361.fm5 Page 19 Thursday, May 9, 2002 6:01 PM INSTALLATION Cooktop The cooktop must be set into a worktop between 20 mm and 50 mm thick. There must be nothing between the cooktop and the oven (cross rails, brackets, etc.). Cut an opening in the worktop of the dimensions shown in the product description sheet supplied separately. If not already present, fit the supplied seal to the cooktop flange after cleaning the contact area as shown in the figure.
3gb54361.fm5 Page 20 Thursday, May 9, 2002 6:01 PM ELECTRICAL CONNECTION Make sure the appliance is installed and connected to the electricity supply by a qualified technician in accordance with the manufacturers instructions and in compliance with local regulations. The installer is responsible for the correct electrical connection of the appliances and the observance of the relative safety recommendations.
3gb54361.fm5 Page 21 Thursday, May 9, 2002 6:01 PM BEFORE USING THE APPLIANCES To make the most of your new appliances read the user instructions carefully and keep them on hand for consultation in the future. Remove the cardboard protections and the protective plastic film. Remove the accessories from the oven and heat it at 200° C for about an hour to eliminate the smell of protective grease and insulating materials. Keep the window open during this procedure.
3gb54361.fm5 Page 22 Thursday, May 9, 2002 6:01 PM POWER ADJUSTMENT Easytronic set is set to absorb maximum 3 kW power; if necessary, however, the maximum power absorbed can be adjusted to the following values: 2.5 - 4.5 - 6 - 7kW. Check that the power in the home is compatible with the power you wish to set. Any power adjustment must be performed exclusively by the Whirlpool After Sales Service. POWER CABLE (H05RR-F) SET POWER (kW) 3 x 1.5 mm2 2.5 3 x 1.5 mm2 3 3 x 1.5 mm2 4.5 3 x 2.
3gb54361.fm5 Page 23 Thursday, May 9, 2002 6:01 PM PRECAUTIONS AND GENERAL RECOMMENDATIONS Disconnect from the electrical power supply before any cleaning or maintenance operation. Keep children away from the oven when it is in use and when its has just been switched off. The oven must be repaired or adjusted exclusively by a qualified technician.
3gb54361.fm5 Page 24 Thursday, May 9, 2002 6:01 PM ENERGY SAVING TIPS Use pots and pans whose bottom diameter is equal to that of the cooking zone or slightly larger. Only use flat-bottomed pots and pans. If possible, keep the pot covered when cooking. Cook vegetables, potatoes, et. with little water in order to cut down cooking time. A pressure cooker allows you to save even more energy and time.
3gb54361.fm5 Page 25 Thursday, May 9, 2002 6:01 PM OVEN FUNCTIONS Functions vary depending on the model (refer to the Product Description Sheet supplied separately). (PREHEAT - PHt) Some of the oven functions require an initial preheating time that consists in bringing the oven rapidly to the selected temperature, using the top heating element. When this phase is in progress, the letters PHt flash on the display.
3gb54361.fm5 Page 26 Thursday, May 9, 2002 6:01 PM COOKTOP FUNCTIONS The cooktop control knobs are marked with a numerical scale corresponding to different power settings, and a series of function symbols. KEEP WARM FUNCTION This function uses a low power setting so that food can be kept warm when cooking is finished. How to operate: 1. Set the knob to . 2. To deactivate the Keep Warm function, change the knob position.
3gb54361.fm5 Page 27 Thursday, May 9, 2002 6:01 PM CLEANING THE OVEN AND ACCESSORIES When you finish cooking, wait for the oven to cool and then clean it to prevent the build-up of baked-on residues. If the food residues are baked on, use a specific oven cleaner and follow the manufacturers instructions on the pack. Clean the exterior of the oven with a damp sponge and warm water. Do not use abrasive cleaners or pan scourers. Use a liquid detergent to clean the oven door window.
3gb54361.fm5 Page 28 Thursday, May 9, 2002 6:01 PM CARE AND MAINTENANCE OF THE ELECTRIC COOKTOP Before cleaning the cooktop, disconnect it from the electrical supply and wait until it has cooled. Care and maintenance of the conventional electric cooktop Clean using a cloth and warm soapy water. Do not use abrasives, corrosive cleaners, cleaners containing chlorine or pan scourers. Do not leave acidic substances on the cooktop (vinegar, salt, lemon juice, etc.).
3gb54361.fm5 Page 29 Thursday, May 9, 2002 6:01 PM TROUBLESHOOTING GUIDE Oven not working Disconnect the appliance from the mains for a few minutes and then switch it on again to see if the problem persists. Check for the presence of mains electrical power. If the display shows the message STOP, check that the oven control knob is not turned to 0, press button 2 and set the clock (see the Programmer Description Sheet supplied separately).
