Operation Manual

18
Glass-ceramic hob
IMPORTANT: Remove any protective film before installing the hob.
Make sure that that the opening in the worktop for the hob is cut according to the dimensions given in
the drawing on the Product Description Sheet. Pay attention to the tolerance range.
The hob should not be forced into the worktop. Forcing the glass-ceramic top may cause it to crack
(even at a later date)!
If the worktop is made of wood, use the spring clips and screws provided (fig. 8).
1. Secure the spring clips (D) (fig. 8) with the screws provided (E) (fig. 8) as shown, paying attention to
the specified distances.
2. Fit the hob into the worktop.
If the worktop is made of marble, plastic, ceramic, stone, etc., the hob must be secured with
special brackets (F) (fig. 8), Code 4819 404 78697 available at After Sales Service.
1. Fit the hob into the worktop.
2. Place the 4 brackets (F) in position in accordance with the thickness of the worktop as shown in fig. 9.
3. Fasten the 4 screws (G) in the positions (H) (fig. 9).
8
9