Operation Manual

Interconnecting hob and oven

IMPORTANT: do not connect the oven to the power supply before you have finished connecting the

oven and hob.

• Before connecting the oven to the power supply, make sure that the hob is among the ones listed in

the hob/oven pairing product sheet provided.

• Connect the hob connectors (C) (Fig. 10) to the oven connectors (D), making sure that you match the

colours and that the connector slots are aligned.

• Insert the connectors and push them in until they click into place.

• Unscrew the nut of the ground screw (H) (Fig. 10) located on the top covering of the oven and

insert the yellow/green earth wire, leaving the washer in place. Firmly retighten the nut of the ground

screw.

Important: if the hob terminals do not match the connection and colours given on the connection label

located on the top of the oven, require the adapter kit, code AMC 873, available from After Sales Service.

Securing the oven

• Lift up the oven getting hold of it by the openings on the sides and insert it into the housing unit, being

careful not to trap the power supply cable (fig.11).

• Center the oven in the housing unit before securing it.

• Make sure that the plastic spacers are positioned correctly in the fastening holes. Then anchor the oven

to the housing unit with the screws provided (Fig.12).