Installation Instructions


5019 318 33000
AKR419-420-424-425-426-427-428-429-430-601-619-620-624-625-626-627-628-629-720
1.
Control panel
2.
Grease filters (behind the extractor grille)
3.
Lighting unit (not present in AKR 427-627-720)
4.
Pull-out steam deflector
5.
Halogen bulbs (AKR 427-627-720 only)
Removing and renewing or cleaning the
grease filter:
1.
Disconnect the electrical power supply.
2.
Pull out the steam deflector
(Fig.1,a)
.
3.
Open the extractor grille
(Fig.1,b-c-d)
.
4.
Remove the device securing the grease filter
(
Fig. 2,e
or
Fig. 3,e
).
5.
Remove the dirty grease filter.
6.
After the grease filter has been replaced or
cleaned (depending on model), refit the parts in
reverse order, making sure the entire extraction
surface is covered.
Fitting or renewing the carbon filter:
1.
Disconnect the electrical power supply.
2.
Pull out the steam deflector.
3.
Open the extractor grille.
4.
If the carbon filter is already fitted and needs
renewing, press the release buttons
(Fig. 4,h)
and pull the filter out downwards.
5.
If the filters are nor already fitted
(Fig. 4)
.
f.
Locate the carbon filter on the back rings.
g.
Secure the filter in front with the clips (h)
supplied with it.
6.
Refit the extractor grille.
Replacing bulbs
1.
Disconnect the electrical power supply.
2.
Pull out the steam deflector.
3.
Open the extractor grille.
4.
Remove the burnt-out bulb. Replace using 40 W
max E14 bulbs or 20 W max GU5.3 halogen bulbs
only (models AKR 427-627-720 only) or 9 W PL
bulbs (models AKR 419-426-619-626 only).
5.
Refit the extractor grille.
CONTROL PANEL
A.
Light switch
B.
Speed selector switch
small amount of steam and fumes
medium amount of steam and fumes
large amount of steam and fumes
large amount of steam and fumes
FIG. 1
FIG. 2
FIG. 3
FIG. 4
F NL E PD GRI
GB
PRODUCT SHEET
31833000.fm5 Page 6 Tuesday, March 20, 2001 3:29 PM