Instruction for Use

AKT 616 PRODUCT DESCRIPTION SHEET
GB
5019 319 62043/A
To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation.
AU
LIGHTING THE BURNERS
• To ignite one of the burners, turn the relative knob anti-clockwise to the maximum flame setting .
• Press the knob against the control panel to ignite the burner.
• Release the knob.
- If the flame goes out, repeat the operations described above.
- Should the flame accidentally go out, close the corresponding control knob and wait for at least 1 minute
before igniting the burner again.
PRATICAL ADVICE FOR USING THE BURNERS
For better burner performance, please stick to the following rules:
- Use pots and pans that fit the burners
(see table on the right).
- Only use flat-bottomed pots and pans.
- Use the correct amount of water for cooking foods and
keep the pot covered.
Due to continued product development, Whirlpool
reserves the right to change specifications or model
availability without notice.
1.
Removable panstand grids
2.
Auxiliary burner
3.
Semi-rapid burner
4.
Semi-rapid burner
5.
Ultra-rapid burner
6.
Auxiliary burner control knob
7.
Semi-rapid burner control knob
8.
Semi-rapid burner control knob
9.
Ultra-rapid burner control knob
SYMBOLS
Tap closed
Maximum flame
Minimum flame
Burner Pot Ø
ultra-rapid
from 24 to 26 cm
semi-rapid
from 16 to 22 cm
auxiliary
from 8 to 14 cm
DIMENSIONS AND DISTANCES TO BE MAINTAINED (mm)
NOTE: In case of installation of a hood above the cooktop, please refer to the hood instructions for the correct
distance.
ELECTRIC SUPPLY: 230 -240 V - 50 Hz
BURNER
NG ULPG
Pressure Injector Rate Pressure Injector Rate
(kPa) (mm) MJ/h (kPa) (mm) MJ/h
Front RHS (Auxiliary) 1.00 0.85 4.0 2.75 0.55 4.0
Rear RHS (Semi-rapid) 1.00 1.15 7.0 2.75 0.75 8.0
Rear LHS (Semi-rapid) 1.00 1.15 7.0 2.75 0.75 8.0
Front LHS (Ultra-rapid) 1.00 1.60 13.0 2.75 0.90 12.0