Installation

10
EN
Doneness is available in most of the auto
functions. You have the possibility to personally
control the end result through the Adjust
doneness feature. This feature enables you to
achieve higher or lower end temperature
compared to the default standard setting.
when using one of these functions the oven
chooses the default standard setting. This
setting normally gives you the best result. But if
the food you heated became too warm to eat at
once, you can easily adjust this before you use
that function the next time.
This is Done by selecTing a Doneness level with the
adjust knob right after you have pressed the
Start button.
DONENESS
LeveL effect
high +2 yielDs highesT enD TemperaTure
high +1 yielDs higher enD TemperaTure
meD 0 DefaulT sTanDarD seTTing
low -1 yielDs lower enD TemperaTure
low -2 yielDs lowesT enD TemperaTure
noTe:
The Doneness can only be set or altered during
the rst 20 seconds of operation.
START PROTECTION / KEY LOCK
This auTomaTic safeTy funcTion is acTivaTeD one
minuTe afTer the oven has returned to
“stand by mode“ (the oven is in “stand
by” when the 24-hour clock is
displayed or if the clock has not been set,
when the display is blank).
The Door musT be openeD anD closeD e.g. putting
food into it, before the safety lock is released.
Else the display will show “DOOR”.
DONENESS (auto functions onLy)