Instruction for Use

7
EN
PRIOR TO CONNECTING
MOUNTING THE APPLIANCE
INSTALLATION
AFTER UNPACKING THE APPLI ANCE, make sure that it has
not been damaged during transport and that the
appliance door closes properly.
I
N THE EVENT OF PROBLEMS , contact the dealer or the
nearest After-sales Service.
F
OLLOW THE SUPPLIE D SEPARA TE MOUN TING INS TRUC TIONS
when installing the appliance.
C
HECK THAT THE VOLTAGE on the rating plate
corresponds to the voltage in the home.
D
O NOT REMOVE the microwave inlet protection
plates located on the side of the microwave
oven cavity wall. They prevent grease & food
particles from entering the microwave inlet
channels.
E
NSURE THE MICROWAVE oven cavity is empty before
mounting.
E
NSURE THAT THE APPLIANCE IS NOT DAMAGE D . Check
that the microwave oven door closes firmly
against the door support and that the internal
door seal is not damaged. Empty the microwave
oven and clean the interior with a soft, damp
cloth.
D
O NOT OPERA TE this appliance if it has a damaged
mains cord, if it is not working properly, or if it
has been damaged or dropped. Do not immerse
the mains cord in water. Keep the cord away
from hot surfaces. Electrical shock, fire or other
hazards may result.
I
F THE POWER SUPPLY COR D is too short, have a
qualified electrician or serviceman installer an
outlet near the appliance.
T
HE POWER SUPPLY COR D must be long enough for
connecting the appliance, once fitting in its
housing, to the main power supply.
F
OR INS TALLATION to comply with current safety
regulations, an omnipolar switch with
minimum contact gap of 3 mm must be utilized.
AFTER CONNECTING
T
HE APPLIANCE can be operated only if the
microwave oven door is firmly closed.
T
HE EAR THING OF THIS APPLIANCE IS COMPULSORY . The
manufacturer will accept no responsibility for
injury to persons, animals or damage to objects
arising from the non-observance of this
requirement.
T
O PREVENT ANY DAMAGE , only remove the appliance
from its polystyrene foam base at the time of
installation.
C
HILDREN SHOULD NOT PERFORM INSTALLATION OPER ATIONS .
Keep children away during installation of the
appliance. Keep the packaging materials (plastic
bags, polystyrene parts, etc.) out of reach of children,
during and after t
he installation of the appliance.
T
HE MANUFAC TURERS are not liable for any
problems caused by the user’s failure to observe
these instructions.
A
FTER INSTALLATION , the bottom of the appliance
must no longer be accessible. For correct
appliance operation, do not obstruct the
minimum gap between the worktop and the
upper edge of the oven.