Instruction for Use

13
Before contacting the After-Sales Service:
1. See if you can solve the problem yourself with
the help of the Trouble-shooting guide.
2. Switch the appliance off and then on again to
check if the problem has been eliminated. If it
has not, switch off the appliance again and
repeat the operation after one hour.
3. If the problem persists after this course of
action, contact After-sales Service.
Specify:
• the type of fault
• the appliance model
• The Service number (the number after the word
SERVICE on the rating plate inside the
appliance)
• Your full address
• Your telephone number and area code
Note:
The direction of door opening can be
changed. If this operation is performed by
After-sales Service it is not covered by the
warranty.
AFTER-SALES SERVICE
• Install the appliance away from heat sources.
Installation in a hot environment, direct
exposure to the sun or installation near heat
sources (heaters, radiators, cookers) will
increase power consumption and should
therefore be avoided.
• If this is not possible, the following minimum
distances must be respected:
- 30 cm from coal or paraffin stoves;
- 3 cm from electric and/or gas stoves.
• Fit the spacers (if supplied) on the rear of the
condenser positioned at the back of the
appliance.
• Install the appliance in a dry, well-ventilated
place, and ensure it is level, using the front
adjustment feet if necessary.
• Clean the interior.
• Fit the accessories.
Electrical connection
• Electrical connections must be made in
accordance with local regulations.
• Voltage and power consumption are indicated
on the rating plate inside the appliance.
• Regulations require that the appliance be
earthed. The manufacturer declines all
liability for injury to persons or animals and
for damage to property resulting from
failure to observe the above procedures
and reminders.
• If the plug and socket are not of the same type,
have the socket replaced by a qualified
electrician.
• Do not use extension leads or adapters.
Disconnecting the appliance
It must be possible to disconnect the appliance by
unplugging it or by means of a two-pole switch
fitted upline of the socket.
INSTALLATION