Instructions for use
SAFETY INSTRUCTIONS IMPORTANT TO BE READ AND OBSERVED Before using the appliance, read these safety instructions. Keep them nearby for future reference. These instructions are also available on docs.indesit.eu These instructions and the appliance itself provide important safety warnings, to be observed at all times. The manufacturer declines any liability for failure to observe these safety instructions, for inappropriate use of the appliance or incorrect setting of controls.
PERMITTED USE CAUTION: the appliance is not intended to be operated by means of an external timer or separate remote controlled system. This appliance is intended to be used only in household application. This appliance is Not intended to be used in similar application such as: staff kitchen areas in shops, offices and other working environments; farm houses; by clients in hotels, motels, bed & breakfast and other residential environments. This appliance is not for professional use.
ELECTRICAL WARNINGS Prior to connect the appliance verify that the voltage on the rating plate corresponds to the voltage in your home. It must be possible to disconnect the appliance from the power supply by unplugging it if plug is accessible, or by a multi-pole switch installed upstream of the socket and the appliance must be earthed, in conformity with national electrical safety standards. Do not use extension leads, multiple sockets or adapters.
SAFEGUARDING THE ENVIRONMENT DISPOSAL OF PACKAGING MATERIALS SCRAPPING OF HOUSEHOLD APPLIANCES The packaging material is 100% recyclable and is marked with the recycle symbol ( ). The various parts of the packaging must therefore be disposed of responsibility and in full compliance with local authority regulations governing waste disposal. This appliance is manufactured with recyclable or reusable materials. Dispose of it in accordance with local waste disposal regulations.
ACCESSORIES & PARTS 1( k l w q t j r i 2) h o e s a y g u f d q Control panel w Steam knob e Water tank r Power cable t Steam/hot water tube y Drip mesh u Drip tray 6 i Cappuccino maker o Nozzle a Boiler outlet s Presser d Filter holder f Large two-cup filter g Small one-cup h Steam selector button j Coffee/hot water button k ON/OFF button l ON light 1( Temperature OK light (coffee or hot water) 2) STEAM indicator light
FILLING THE WATER TANK q Remove the watertank by pulling it out (towards the front). w Fill the tank with fresh clean water taking care not to exceed the MAX level. Refit the tank. Never use the appliance without water in the tank and always remember to top up when the level drops to a couple of centimetres from the bottom. AUTO OFF For energy saving purposes, the appliance has an automatic switch-off function (the power light goes off ), if it is not used for a long period of time.
HOW TO PREPARE ESPRESSO COFFEE USING THE FILTER HOLDER FOR GROUND 1. After preheating the appliance as described above, place the ground coffee filter in the filter holder, making sure the projection is correctly inserted in the slot. Use the smaller filter to make one coffee or the larger filter to make two coffees. 2. To make a single coffee only, place one level measure (about 7 g) of ground coffee in the filter.
HOW TO PREPARE ESPRESSO COFFEE USING PODS 1. Preheat the appliance as described in the section “PREHEATING THE COFFEE UNIT”, making sure the filter holder is attached. This obtains a hotter coffee. Note: Use pods conforming to the ESE standard indicated on the pack with the following logo: The ESE standard is a system accepted by leading pod producers and enables espresso coffee to be prepared simply and cleanly. 2.
HOW TO MAKE CAPPUCCINO COFFEE 1. Prepare the espresso coffees as described in the previous paragraphs, using sufficiently large cups. 2. Press the steam button and wait for the OK light to come on. This indicates that the boiler has reached the ideal temperature for steam production. 3. In the meantime, fill a recipient with about 100 grams of milk for each cappuccino to be prepared. The milk must be at refrigerator temperature (not hot!).
Note: always clean the cappuccino maker after use. Proceed as follows: 3. Remove the nozzle from the steam tube by pulling it downwards. 1. Discharge a little steam for a few seconds by rotating the steam knob. This empties any milk left inside the steam spout. 4. Wash the cappuccino maker and steam nozzle thoroughly with warm water. Note: to ensure hygiene, you are recommended to follow this procedure each time you make cappuccino to avoid milk stagnating in the milk circuit. 5.
CLEANING AND MAINTENANCE 1. Before performing any cleaning operations, leave the appliance to cool down and unplug from the mains socket. 2. Do not use solvents or abrasive cleaning products to clean the appliance. A soft, damp cloth is sufficient. 3. Empty and wash the drip tray and drip mesh frequently. 4. Clean the water tank regularly. CLEANING THE FILTER HOLDER About every 200 coffees, clean the filter holder for ground coffee as follows: ɳɳReplace the filter and gasket on the plastic disk.
CLEANING THE BOILER OUTLET About every 300 coffees, the espresso boiler outlet must be cleaned as follows: 1. Make sure the appliance is not hot and that it is unplugged from the mains. 3. Clean the boiler with a damp cloth. 4. Clean the outlet thoroughly in hot water using a brush. Make sure the holes are not blocked. If necessary, clean with a pin. 5. Rinse under running water, rubbing all the time. 6. Screw the boiler outlet back on. Failure to clean as described above invalidates the guarantee. 2.
Problem Possible cause Solution No espresso coffee is delivered ɳɳNo water in the tank. ɳɳThe holes in the filter ɳɳFill the tank with water. ɳɳClean the spout holes. ɳɳClean as described in the ɳɳ ɳɳ ɳɳ The espresso coffee drips from the edges of the filter holder rather than the holes. The espresso coffee is cold indicator light was not on when the coffe switch was pressed. No preheating performed. The cups were not preheated.
Problem The coffee froth is too light (delivered from the spout too fast) The coffee froth is too dark (delivered from the spout too slowly) Possible cause Solution ɳɳThe ground coffee is ɳɳPress the ground coffee down more firmly). ɳɳIncrease the quantity of ground coffee. ɳɳUse ground coffee for ɳɳ ɳɳ ɳɳ not pressed down firmly enough. There is not enough ground coffee. The ground coffee is too coarse. Incorrect type of ground coffee. ɳɳThe ground coffee is pressed down too firmly.
HOW TO OBTAIN THE USE AND CARE GUIDE ɳɳ ɳɳ WWW Download the Use and Care Guide from our website docs.indesit.eu (you can use this QR Code), specifying the product’s commercial code. Alternatively, contact our Client After-sales Service. CONTACTING OUR AFTER-SALES SERVICE You can find our contact details in the warranty manual. When contacting our Client After-sales Service, please state the codes provided on your product’s identification plate.