Health & Safety, Use & Care and Installation guide
ENGLISH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
EN ENGLISH HEALTH & SAFETY, USE & CARE and INSTALLATION GUIDES THANK YOU FOR BUYING AN IGNIS PRODUCT. Index Health and Safety guide SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 SAFEGUARDING THE ENVIRONMENT. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CLEANING & MAINTENANCE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 EMPTYING THE WATER TANK. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 CLEANING THE DOOR FILTER .
EN Health and Safety guide SAFETY INSTRUCTIONS IMPORTANT TO BE READ AND OBSERVED Before using the dryer carefully read, Health and Safety and Use and Care guides. Keep these instructions close at hand for future reference. YOUR SAFETY AND SAFETY OF OTHERS IS VERY IMPORTANT. This manual and the dryer itself provide important safety warnings, to be read and observed at all times. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.
leading to a damaging of the laundry. If you want to stack the dryer on a washing machine, first contact our After-Sales Service to verify if this is possible. Stacking of a dryer is only admitted if the dryer is safely fixed on the washing machine by using an appropriate stacking kit. INTENDED USE OF THE PRODUCT This dryer is designed solely for domestic usage. To aim the dryer as professional use is forbidden.
EN The dryer is not designed for built-in installation. The dryer can be installed under a worktop, provided that adequate ventilation of the dryer is assured. Install a ventilation grid (minimum 45 cm x 8 cm), in the rear part of the worktop under which the dryer is installed. ELECTRICAL WARNINGS Make sure the voltage specified on the rating plate corresponds to that of your home. For installation to comply with current safety regulations, an omnipolar switch with minimum contact gap of 3 mm is required.
CLEANING AND MAINTENANCE The dryer must be disconnected from the power supply before carrying out any cleaning or maintenance operation. Never use steam cleaning equipment. SAFEGUARDING THE ENVIRONMENT For dryer models with heatpump technology: This dryer contains fluorinated greenhouse gas (R134a). The circuit containing this gas is hermetically sealed. The electrical switchgear has a tested leakage rate of less than 0,1% per year.
EN ENERGY SAVING TIPS Always dry a full load, depending on the type of laundry and the programme/ drying time. For more detailed information, see the programme chart. By preference use the maximum spin speed allowed by your washing machine, since draining the water mechanically requires less energy. You will save time and energy when running your drying cycle. Always select the correct programme/drying time for the load in order to obtain the desired drying results.
Use and Care guide PRODUCT DESCRIPTION APPLIANCE 1. 1. Worktop 2. Control panel 3. Water tank 4. Door 5. Door handle 6. Door filter (behind door) 7. Condenser (= bottom filter; behind flap) 8. Adjustable feet (4) 2. 3. 5. 4. 6. 7. 8. CONTROL PANEL 8. 6. 7.
EN DOOR To open the door, pull the handle. To close the door, hold the handle and push so that you can hear it click shut. If you interrupt a running programme by opening the door, the programme will be reset if the dryer door is not closed again within one minute. DRUM LIGHT (if available) • During programme selection: the light goes on for laundry loading • After programme start: the light fades on and off while the laundry load is detected.
HOW TO USE THE APPLIANCE FIRST TIME USE 1. CHECK WATER TANK Make sure that the water tank is correctly inserted 2. CHECK DRAIN HOSE Make sure that the drain hose on the back of the dryer is fixed, either to the dryer’s water tank or to your domestic sewage system (see INSTALLATION GUIDE).
EN DAILY USE WARNING Make sure that no lighters or matches remain in the laundry. 1. LOAD THE LAUNDRY Make sure that the laundry is not soaked with flammable liquids. Respect the care labels of your laundry; make sure that it is appropriate for being treated in a dryer. Select options, if needed If you want to select additional options, press the respective button - the indicator lights up. Drying Care Labels The dots indicate the temperature degree for drying the laundry.
If you do not switch the dryer off after programme end, the dryer drum rotates from time to time the next 10 minutes after programme end, to reduce creasing of the laundry. During that time, the Anti-crease indicator lights up. The dryer will switch off automatically in about a quarter of an hour after programme end, to save energy. 8.
EN PROGRAMME Type of Drying and Recommendations ECO COTONE / ECO COTTON Standard cotton programme, suitable to dry normal wet cotton laundry. Most efficient programme in terms of energy consumption for drying cotton laundry. The values on the Energy Label are based on this programme. SINTETICI / SYNTHETICS For drying laundry made of synthetic fibres. max.
PROGRAMME Type of Drying and Recommendations ASCIUGATURA A TEMPO / DRYING TIME Time-restricted drying programme. Select programme duration by option Drying time. For all fabrics appropriate for tumble drying. Suitable to add an additional short drying phase after programme end. max = maximum capacity of the dryer Programme durations indicated in the table are default values. The programme duration mainly depends on the humidity level of the laundry and the volume of the laundry load.
EN OPTIONS OPTIONS WHICH ARE DIRECTLY SELECTABLE BY PRESSING THE RESPECTIVE BUTTON Refer to the Programmes section chart to check which options are available for the selected programme. ASCIUGATURA+ / DRY PLUS Increases the dryness level of your laundry DELICATI / GENTLE Enables a more gentle treatment of the laundry by reducing the drying temperature.
FUNCTIONS KNOB Allows for setting the programme: turn until the indicator points towards the desired programme. The 0 position switches off the dryer and cancel a running programme. WARNING START/PAUSE AVVIO RITARDATO / START DELAY 18 After cancelling a running out so that the heat is programme, quickly remove dissipated. all items and spread them To start the programme, after you have finished your settings To pause a running programme Moves the start of your programme to a later time.
EN INDICATORS FAILURE INDICATORS Serbatoio / Water tank (=> empty water tank) In case of any failures, refer to section TROUBLESHOOTING Filtro aria inferiorie / Bottom filter (=> clean bottom filter). Filtro aria porta / Door filter (=> clean door filter) PROGRAMME SEQUENCE INDICATOR Programme sequence indicator Shows the current programme phase (sensing / drying process / programme end).
ENERGY SAVING AUTOMATIC SWITCH-OFF FUNCTION The dryer is designed to save energy. After the programme has finished, it therefore switches off automatically after about a quarter of an hour. ENERGY SAVING TIPS • The optimum ambience temperature for the dryer is between 15 and 20 °C. In case of a higher temperature, air the room. • To reduce the drying time, make sure that the laundry is spun with the maximum possible spin speed of the wash programme. This reduces the moisture content in the laundry.
EN CLEANING & MAINTENANCE WARNING Do not use flammable fluids to clean the dryer. For any cleaning and maintenance, switch off the dryer. EMPTYING THE WATER TANK Empty the water tank after each programme, provided the drain hose is not connected to your sewage system (refer to INSTALLATION GUIDE). 1. Hold the handle and carefully pull out the water tank. Hold the full water tank with both hands. 3. Insert the water tank by pushing it back into place.
CLEANING THE DOOR FILTER 3. Clean the door filter after each cycle. Make sure that the laundry is unloaded. Open the door. Carefully remove the complete lint from the screen by hand. If needed, the screen can be cleaned also under running water, using a soft brush. 2. Press the button to open the door filter. Clean the filter compartment with a soft cloth, or carefully with a vacuum cleaner. 1. Remove the door filter by pulling it upwards. 4. 5.
EN CLEANING THE BOTTOM FILTER Clean the bottom filter about every two months. 1. Carefully press down the strap to open the bottom flap. 2. Turn the locking bars right and left on the bottom filter downwards in horizontal position. 3. Hold the bottom filter on the handle and pull it out. 5. Wipe the bottom filter dry, so that it is not dripping wet anymore. 6. Clean the filter compartment with a soft cloth or carefully with a vacuum cleaner. 7.
CLEANING THE OUTSIDE OF THE DRYER Use a soft damp cloth to clean the outer parts of the dryer. Do not use glass or general purpose cleaners, scouring powder or similar to clean the control panel – these substances might damage the surfaces.
EN REVERSING THE DOOR STOP If needed, the door stop of the dryer door can be reversed. Use pliers and a cross-head screwdriver for the procedure. 1. Use pliers to turn the contact pin at the inside of the door towards the right by 90° and pull it out. For removing and fixing the door, the help of a second person is recommended. Make sure that the dryer is unplugged. Open the dryer door. 3. Press the small knob above the door lock with a small screwdriver.
5. Fix the door on the left side by turning in the 7. Fix the 2 screws above and below the door lock 2 screws. Take care to screw them in vertically, to avoid pinching off the door seal. 6. Insert the door lock on the right side of the door opening. Press it completely inside the hole and move it a bit downwards, until the small knob of the door lock latches. 26 system. 8. Insert the contact pin on top inside of the door. Turn the contact pin with pliers by 90° towards the right, to lock it.
EN TROUBLESHOOTING GUIDE & AFTER-SALES SERVICE Your dryer is equipped with various automatic safety functions. These enable failures to be detected in good time and the safety system can react appropriately. These failures are frequently so minor that they can be removed within a few minutes.
DRYER DOES NOT START, ALTHOUGH START/PAUSE HAS BEEN PRESSED WATER DROPLETS ARE BENEATH THE DRYER 28 Door not properly closed • Push door to close it until it clicks shut Key lock is activated • Press and hold the button with the key symbol until the display indicates that the keys are unlocked. Plug, power failure, fuse • The plug is not in the socket or making contact. • There has been a power failure. • The fuse has blown. Try to plug another appliance into the socket.
EN FAILURE INDICATOR AND MESSAGES Make sure to • Empty the water tank after each programme • Clean the door filter after each programme • Clean the bottom filter about every two months Failure Indicator Possible Cause The empty “Serbatoio / Water Tank” lights on Water tank may be The “Filtro aria inferiore / Bottom Filter” lights on The “Filtro aria porta / Door Filter” lights on Solution • filled with water • Empty water tank; make sure to insert it properly afterwards.
Below is a summary of possible failure causes and solutions. If the problem persists after having followed the instructions as indicated below, switch off, unplug the dryer and contact the After‑Sales Service. FAULT CONDITION The 3 red LEDs are blinking and some green LEDs are turn on. Failure Codes Solution F1 F2 F3 Turn the programme selector to 0/OFF then at least wait for 3 seconds. F4 F5 F6 F7 30 Switch off and unplug the dryer.
EN TRANSPORT AND HANDLING WARNING Never lift the dryer by holding it at the worktop. 1. Unplug the dryer. 2. Make sure that door and water tank are 3. If the drain hose is connected to your sewage system, fix the drain hose on the rear of the dryer again (see Installation Guide). properly closed.
AFTER-SALES SERVICE BEFORE CALLING THE AFTER-SALES SERVICE 1. See if you can solve the problem by yourself with the help of the suggestions given in the TROUBLESHOOTING GUIDE. 2. Switch the appliance off and on again to see if the failure persists. IF AFTER THE ABOVE CHECKS THE FAILURE STILL OCCURS, GET IN TOUCH WITH THE NEAREST AFTER-SALES SERVICE To receive assistance, call the number shown on the warranty booklet or follow the instructions on the website www.whirlpool.
EN 1. 2a. 2b.
3a. max 2 cm max 0.79 inch 3b.
EN 4.
5. 6a. 6b. ..............
