Service manual

4-4
REMOVING THE CONTROL POWER AND
THE MICROWAVE LIGHT TRANSFORMERS
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
MW Light Transformer
5. To remove the control power trans-
former:
a) Disconnect the 2-wire transformer connec-
t
or from the left side panel connector.
b) Remove the two screws from the trans-
f
ormer and remove the transformer.
2-Wire Connector
Screws
6. To remove the microwave light trans-
former:
a) Disconnect the two pink wire connectors
from the LOAD terminals, and the two
brown wire connectors from the LINE
terminals.
b) Remove the two screws from the trans-
f
ormer and remove the transformer.
BR Wires
PK Wires
MW Light Transformer
Screw
Screw
1. Unplug oven or disconnect power.
2. Open the microwave oven door, remove
the two flat-head screws from the bottom
of the control panel frame, and remove the
frame.
Control Panel Frame Screws
3. Remove the four screws from the front
subpanel and remove the subpanel as-
s
embly.
4. Disconnect the P1 and P2 connectors from
the microwave and lower oven control board
connectors and set the panel assembly
aside.
Front Subpanel Screws
P2 P1 P2 P1
Lower Oven Board
MW Oven Board
Control Power Transformer
Control Power Transformer Screws
2-Wire Connector