Service manual

4-6
REMOVING THE MONITOR FUSE AND
THE MICROWAVE APPLIANCE MANAGER
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
5. To remove the monitor fuse holder:
a) Remove the fuse from the fuse holder.
b) Disconnect the two wire connectors
from the fuse holder terminals.
c) Remove the screw from the fuse holder
and remove the fuse holder.
6. To remove the microwave appliance
manager:
a) Remove the two screws from the left
side of the board and remove the board
from its holder.
b) Disconnect the wire connectors from
the board (see below for the wiring).
Fuse Holder Screw
BR
BR
Microwave Appliance Manager Screws
RL1
BU
RL2
RD
RL3
BR
WH
(SM)
BK WH
(LG)
P3
BU-YL
2 BK-2 BR & 4 BK
P10
6-Pin
HUM
3-Pin
P6
2-Pin
P8
3-Pin
1. Unplug oven or disconnect power.
2. Open the microwave oven door, remove
the two flat-head screws from the bottom
of the control panel frame, and remove the
frame.
Control Panel Frame Screws
3. Remove the four screws from the front
subpanel and remove the subpanel as-
s
embly.
4. Disconnect the P1 and P2 connectors from
the microwave and lower oven control board
connectors and set the panel assembly
aside.
Front Subpanel Screws
P2 P1 P2 P1
Lower Oven Board
MW Oven Board
Monitor Fuse
P1=BU-BR
Monitor Fuse
Microwave Appliance Manager