Service manual

4-11
REMOVING THE MAIN L1 FILTER, MAIN L2 FILTER,
AND GRILL THERMOSTAT
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Top Cover
Screws (2 of 4)
1. Unplug oven or disconnect power.
2. Remove the oven from its mounting location
(see “Installation Information” in Section 2)
and pull it forward so that you can access
the top cover.
3. Remove the four screws from the top cover
and remove the cover.
4. Remove the eight screws from the inner
cover and remove the cover.
Inner Cover Screws (3 of 8)
Main L2 Filter
5. To remove the main L1 filter:
a) IMPORTANT: Discharge the main L2
filter by touching the leads of a 20,000
ohm resistor to the terminals and chas-
s
is ground.
b) Remove the filter bracket screw, unhook
the top and bottom bracket tabs, and
remove the bracket from the left side
panel.
Grill Thermostat
Main L1 Filter
Bracket Screw
Main L1 Filter
Continued on the next page.