Service manual

4-24
REMOVING THE TURNTABLE MOTOR
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug oven or disconnect power.
2. Remove the oven from its mounting location
(see “Installation Information” in Section 2)
and pull it forward so that you can access
the top cover.
3. Remove the four screws from the top cover
and remove the cover.
Top Cover
Screws (2 of 4)
6. Remove the six screws from the left and
right rails and remove the rails from the
oven.
4. Open the microwave oven door, remove
the two flat-head screws from the bottom
of the control panel frame, and remove the
frame.
Control Panel Frame Screws
5. Remove the four screws from the front
control subpanel, remove the subpanel
assembly, and lay it on top of the oven.
Front Subpanel Screws
6 Screws
Right Side Rail