Installation guide

Cabinet Dimensions
Cabinet Side View
Warming
drawer
front
22%"
(57.8 cm)
recessed
I oven depth
24"
(61 cm)
min cutout
depth
Cabinet Front View
Support surface must be
solid, level, flush with
bottom of cabinet cutout.
o o
I
120 volt
grounded
outlet
(or located
in adjaceni
cabinet) *_
_______1.
2V=" (6.4 cm) min.
9_/_'' (23.2 cm)
2"/= '' (6.4 cm) rain.
+
_/_" (23.2 cm)
I Recommended 4V," (10.8 cm)
Minimum 1" (2.5 cm)
4" (10.2 cm)
+
A. 28V_" (72.4 cm) cutout width
B. 30" (76.2 cm) min. cabinet width
Warming drawer can be installed as an indoor single or double
installation or installed under a single oven. Two warming drawers
under a single oven are shown.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
IMPORTANT: The warming drawer must be electrically grounded
in accordance with local codes and ordinances, or in the absence
of local codes, with the National Electrical Code, ANSI/NFPA 70 or
Canadian Electrical Code, CSA C22.1.
If codes permit and a separate ground wire is used, it is
recommended that a qualified electrical installer determine that
the ground path is adequate.
A copy of the above code standards can be obtained from:
National Fire Protection Association
One Batterymarch Park
Quincy, MA 02269
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
• A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is
required. A time-delay fuse or circuit breaker is also
recommended. It is recommended that a separate circuit
serving only this warming drawer be provided.
• The model/serial rating plate is located above the left-hand
side receiving slide. The warming drawer must be removed to
view the model/serial rating plate. See the illustration below.
i
A. Model/serial number plate