Instruction for Use

24
8.2. FAILURES
In the event of operation alarms, they will also be displayed in the digits LEDs, (e.g. Failure1, Failure 2, etc...) call
After-sales Service and specify the alarm code. The acoustic alarm sounds, the Alarm icon
lights up and the F
letter on the digit display blinks according to failure code described below:
Failure code Visualization
Error 2
F letter blink on/off at 0,5 sec. Blinks ON 2 times
then remain off for 5 seconds. Pattern repeats.
x2
Error 3
F letter blink on/off at 0,5 sec. Blinks ON 3 times
then remain off for 5 seconds. Pattern repeats.
x3
Error 6
F letter blink on/off at 0,5 sec. Blinks ON 6 times
then remain off for 5 seconds. Pattern repeats.
x6
9. AFTER-SALES SERVICE
Before contacting After-Sales Service:
Switch the appliance on again to see if the problem
has been solved. If it has not, disconnect the appliance
from the power supply and wait for about an hour
before switching on again.
If, after performing the checks described in the
Troubleshooting Guide and switching the appliance
on again, your appliance still does not work properly,
contact the After-sales Service, explain the problem.
Specify:
• themodelandapplianceserialnumber(statedon
the rating plate),
• thenatureoftheproblem,
• theServicenumber(thenumberaftertheword
SERVICE on the data plate on the inside of the
appliance),
• yourfulladdress,
• yourtelephonenumberandareacode.
Note:
The direction of door opening can be changed. If this
operation is performed by After-sales Service it is not
covered by the warranty.