Installation guide

ManualsBrandsWhirlpool ManualsConvection OvenGM8155XJB2

BUILT-IN TRIM KIT INSTALLATION INSTRUCTION

(KEEP FOR FURTHER REFERENCE)

FOR WHIRLPOOL TRIM-KIT MODELS' MK1157XJ, MK1150XJ

° FOR USE WITH WHIRLPOOL AND KITCHEN AID MICROWAVE OVEN MODELS :

GM8155XJ, KCMC155J, YKCMC155.1

• UL AND CSA LISTED - FOR USE OVER ELECTRIC HEAT SOURCE

(INCLUDING MODELS-27": (Y)RBS275PD, (Y)GBS277PD, (Y)KEBI171D, (Y)KEBS177D

-30" : (Y)RBS305PD, (Y)GBS307PD, (Y)KEBI101D, (Y)KEBS107D

PARTS LIST

Trim Kit

1• Screws

(4 Req'd 2 Extra)

Upper Duct (1)

Rear Duct (1)

BottomDuct (1)

CUTOUT DIMENSIONS

Height

Width

Depth

(min.)

27" 30"

17 1/4"

25 I_,, 281/2"

21 lr2"with flush mount receptacle.

(23 3/4"if non-flush receptacleis used.)

1/2" Screws

(16 Req'd 2 Extra)

Anti-Tip

Bracket (1)

Bottom

Bracket (1)

Template (1)

r__ Depth

Width ;'#:

_ I Height

P/NO.: 3828W5U0078/8172219

Summary of content (4 pages)

PAGE 1
BUILT-IN TRIM KIT INSTALLATION INSTRUCTION (KEEP FOR FURTHER REFERENCE) FOR WHIRLPOOL TRIM-KIT MODELS' MK1157XJ, MK1150XJ i ° FOR USE WITH WHIRLPOOL AND KITCHEN AID MICROWAVE OVEN MODELS : GM8155XJ, KCMC155J, YKCMC155.
PAGE 2
STEP1 Electrical Shock Hazard Disoonnect power before installing trim kit. Replace all panels before operating. Failure to do so can result in death or electrical shock. 1. Remove any loose items inside the microwave oven. Front 2. Disconnect the microwave oven before proceeding with installation. Rear 3. Fasten the bottom bracket to the bottom duct by using four 1/2" screws. 1/2" screws (4) 4. Install rear duct to the bottom duct 1/2" screws (1) with one 1/2" screw.
PAGE 3
STEP3 1. On the cutout floor, mark hole centers for the anti-tip brackets as shown using the supplied template. Be sure to align the center line of template to center line of cutout floor. 2. Ddll two holes for anti-tip bracket. (use 7/64" drill or #35 drill) Corflor Line 3. Install anti-tip bracket onto cutout floor using two 1/2" screws. Cutout Floor DIMENSIONS: _:=1/2" Screws (2) A = 13/16" Anti-Tip erackm B=3" C -----20 1/16" STEP4 1. Slide microwave oven part way into cabinet ope0ing.
PAGE 4
STEP 5 Pilot Ilole 1 1. Place the trim kit frame over the microwave oven. Important Note : Trim kit frame orientation is important. Orient the frame so that louvers are sloping downward to the front. (See Figure Detail "B"). 1"Screws(4) 2. Make sure the trim kit is level and centered with respect to microwave oven. Mark four hole centers through the four mounting holes of the trim kit. NOTE: Center the trim kit frame equally on all four sides. TrimKit 3. Remove the trim kit and drill four pilot holes.