Instruction for Use

7
5. WHAT TO DO IF...
If a fault occurs,
before contacting
the After-sales Service, make the following checks to try and remedy the
problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal
appliance operation.
The appliance... Possible causes/solutions
...is not working/will not start - The appliance must be switched on.
- Check the household circuit fuse if there is no power supply.
- The dishwasher door must be closed.
- Check whether the “Delayed start” function (if available) has
been selected. If it has, the appliance will only start once the set
time has elapsed. If necessary, set the delayed start to “0”
(RESET the appliance).
... shows “F1” on the display or
the START indicator lamp flashes once
- The water supply temperature must be above 3°C.
... shows “F4” on the display or
the START indicator lamp flashes 4 times
- The filters must not be dirty or clogged.
- The drain hose must not be kinked.
- The closure disk of the syphon hose connection must be
removed.
... shows “F6” on the display or
the START indicator lamp flashes 6 times
- The water tap must be open.
- The water inlet hose must not be kinked and the relative inlet
filter in the water tap connector must not be clogged.
... shows “F7” on the display or
the START indicator lamp flashes 7 times
- The water tap must be fully open during water inlet (minimum
capacity: 0.5 litres per minute).
- The water inlet hose must not be kinked and the relative inlet
filter in the water tap connector must not be dirty.
... shows “F8” on the display or
the START indicator lamp flashes 8 times
- The filters must not be dirty or clogged.
- Concave items (e.g. bowls, cups) must be arranged facing
downwards in the rack.
- The drain hose must be fitted correctly (for high built-in
appliances, leave min. 200-400 mm from the lower edge of the
appliance - see instructions in “Maintenance and Installation”).
... shows other “F” faults on the display or
the START indicator lamp flashes Xx times
- Reset the appliance (see below).
After taking the above course of action, the fault message must be reset. In the majority of cases the
fault is thus eliminated.
RESET:
➯
Press the START button for approx. 2 seconds until the indicator lamp switches off or
press the RESET button (depending on model).
➯
Close the door.
➯
Water drains automatically for up to 60 seconds.
➯
The appliance is now ready to be restarted.
Crockery and cutlery ... Possible causes/solutions
...are not perfectly clean/have food
residues
- Arrange crockery so that items do not touch each other.
Concave items (e.g. bowls, cups) must be arranged facing
downwards in the rack.
- If necessary, use more detergent, observing the manufacturer's
indications as regards dosage. Always store detergent in a dry
place and do not store it for excessively long periods of time.
- For heavily soiled crockery, select a wash programme with a
higher temperature (see table 1.1 on the first page).
- If you select the “Half load/Multizone” function (if available),
remember to load
only
the upper rack or
only
the lower rack to
increase washing power and thus obtain optimum wash results.