Instruction for Use

5019 496 01064
1
GB
GSIP 6627
Before using the dishwasher, read the
installation and maintenance instructions carefully!
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to different loads, extra functions,
sensor settings (only with sensor programmes), water supply temperatures, water hardness and power supply voltage.
2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories:
for more detailed information on the EN comparison test and
other tests, contact the following address: “nk_customer@whirlpool.com”.
3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with. Standard NF EN 13697 - November 2001.
1. OVERVIEW
Programme selection button
START button
The indicator lights up during operation, flashes when a fault
occurs, and goes off at the end of the programme.
START button RESET function:
Press this button for at least 2 seconds; the selected programme
and options are cancelled. Main failure displays (repeated flashing
of the START indicator lamp) can be cancelled by RESETTING.
Detailed instructions are given in chapter 5 “What to do if...”.
Fault indication and wash time display
In normal operation it indicates the remaining time (h:mm),
whereas with “Delayed start” selected it indicates the time
remaining until programme start (hh).
If “F..” appears on the display, see chapter 5 “What to do if...”.
“Delayed start” button
Press the button (repeatedly) to delay the start of the programme.
Adjustable from 1 to 24 hours. With each press of the button, the
delayed start indicator increases by one hour and after 24 restarts
from 00. Then press the START button. The dishwasher will start
after the set time.
Half Load/Multizone button
Load the upper or lower rack only.
Press once = wash upper rack (the indicator/symbol lights up)
Press twice = wash lower rack (the indicator/symbol lights up)
Press 3 times = Off (Half load/Multizone deactivated).
When washing without the upper rack, press the “Half load” (i.e.
“wash lower rack”) button twice (the corresponding indicator/
symbol lights up).
On / Off button
Table 1.1.
Table of programmes
Detergent
dispenser
Consumption
1)
P
Programmes
Selectable
extra
functions
Loading instructions large small Litres kWh Minutes
1
Sensor + 40-70°C
Normally or very soiled crockery,
including pots and pans.
X X 7-17 0.99-1.58 65-170 ±
1)
2
Pre-Rinse cold
Crockery to be washed later.
4.0 0.03 14 ±
1)
3
Glasses 40°C
Light soiling, for example glasses and
cups.
X 10.0 0.85 125 ±
1)
4
Quickwash 40°C
Lightly soiled crockery, without dry
residuals.
X 10.0 0.65 30 ±
1)
5
Eco
2)
50°C
Normally soiled crockery.
Energy-saving programme.
X X 11.0 1.05 155 ±
1)
6
Hygienic +
3)
Normally or heavily soiled crockery,
with additional antibacterial wash. An
interruption of the programme (e.g.
due to door opening) can compromise
elimination of germs.
X X 13.0 1.50 115 ±
1)

Summary of content (8 pages)