(91.4 cm) (76_2cm) et S6"(91_ Table of Contents/Table des matieres ............................................................................. 2 GZ5730XR Series GZ5736XR Series S6rie GZ5730XR Serie GZ5736XR IMPORTANT: READ AND SAVE THESE INSTRUCTIONS, FOR RESIDENTIAL USE ONLY. IMPORTANT : LIRE ET CONSERVER CES INSTRUCTIONS, POUR UTILISATION Rm_SlDENTIELLE UNIQUEMENT.
% TABLEOF CONTENTS RANGE HOOD SAFETY ............................... iNSTALLATiON REQUIREMENTS ....................... Tools and Parts ..................................... TABLEDES MATIERES 2 S¢:CURITE DE LA HOT'rE DE CUISINI_:RE 4 EXIGENCES D'INSTALLATION .............. ........................ 13 15 4 Outillage et pi6ces ..................................15 LocationRequirements ............................ 4 Exigences d'ernphcernent ......................... 15 ElectricaI Requirements ..
iMPORTANT SAFETY iNSTRUCTiONS WARNING: TO REDUCE THE RiSK OF FIRE, ELECTRIC SHOCK, OR iNJURY TO PERSONS, OBSERVE THE FOLLOWING: m Use this unit only in the manner intended by the manufacturer, if you have questions, contact the manufacturer. m Before servicing or cieaning the unit, switch the power off at the service panel disconnecting means to prevent power from being switched on accidentalIy.
iNSTALLATiONREQUIREMENTS Product Dimensions Gather the required tools and parts before starting installation. Read and follow the safety instructions provided with any tools listed here. Tools needed: level _, compass or 8" (20.3 cm) circle template _, flat blade screwdriver Phillips screwdriver _, pliers _, metal snips drill 11/4"and 1/8"drilI bits _, pencil ruler _, keyhole saw saber saw duct tape Parts needed: _, UL- or CSA-Iisted, 1/,,,(12.
Calculating Vent System Length [] Ventsystem (ifneeded) forinstallation isnotincluded. To calculate the length of the system you need, add the [] Ventsystem mustterminate totheoutside. equivalent feet (meters) for each vent piece used in the system. [] Donotterminate theventsystem inanatticorother Use 31/4'' x 10" (8.3 x 25.4 cm) or 7" (17.8 cm) round vent with a enclosed area. maximum length of 65 feet (19.8 m) for vent system. For best [] Donotuse4"(10.2cm)laundry-type wallcaps.
iNSTALLATiONiNSTRUCTiONS 7" {17,8 cm) round 1. vertica_ vent system If possible, disconnect and move freestanding or slide-in range from cabinet opening to provide easier access to upper cabinet or rear wall. Slide cardboard or hardboard under range before moving range across floor to prevent damaging floor covering. Otherwise put a thick, protective covering over countertop, cooktop or range to protect from damage or dirt. 2.
2, top of hood. Set vent plate and mounting screws aside, 2, Remove tape holding standard filters in place. Remove both filters. Insert flat blade screwdriver into slots in filters. Push 3, Disconnect the light assembly wiring connector. Make sure not to disconnect any wires. A Remove the light panel and set aside. A \ \ , B A. Light panel A. Filterslots B.
g, Remove either top or rear rectangular knockout, if using 7" (17.8 cm) round vent, remove both top rectangular knockout and the semi-circular knockout. Direct Wiring installation --- __. A. Semi-circularknockout B. Toprectangularknockout C. Rearrectangularknockout Electdcam Shock Hazard 10, install damper: Disconnect power before servicing. Replace all parts and panems before operating.
6, Connect thepowersupply ground wiretothegreenground connector andtighten securely. 3, Position therangehoodsothatthelargeendofthekeyhole slotsareoverthescrews. Thenpushthehoodtoward thewall sothatthescrews areintheneckoftheslots. .... A A. Green ground connector 7, Securely tighten the strain relief. 8, Replace the wiring cover. UL-Listed Power Supply A, Keyhole slots (4) B. Mounting screw Cord Kit {U.S. Only} 1, Connect a ULqisted Power Cord Kit (part no=99524057) (U.
RANGEHOODUSE RANGEHOODCARE : Hood control panel !::: ::: : Be sure lights are cool before cleaning the hood, To clean hood 0 A --% HIGH ...................... B LO 1, Disconnect power, 2, Remove filters, 3, Use a damp cloth and a mild detergent to wipe all greaseladen surfaces. Use care when cleaning fan blade - it must not become bent or misaligned, Do not allow water to enter the motor, 4, Make sure all surfaces are completely dry before replacing filters, 5, Reconnect power, A.
REQUESTINGASSISTANCEOR SERVICE if you need assistance or service in U.S.A. Call the Whirlpool Customer hteraction Center toll=free at 1-800-253-1301o Our censuBtants are available to assist you° When calling: Please know the purchase date, and the complete model and serial number of your appliance This information wilI help us better respond to your request.
WHIRLPOOLCORPORATIONMAJORAPPLIANCEWARRANTY ONE YEAR LIMITED WARRANTY For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter Whirlpool ") will pay for FSP replacement parts and repair labor to correct defects in materials or workmanship. Service must be provided by a Whirlpool designated service company. ITEMS WHIRLPOOL WILL NOT PAY FOR 1.
SECURITEDE LA HOTTEDE CUISINIERE Votre s_curit_ et celle des autres est tr_s importante. Nous donnons de nombreux messages de securite importants dans ce manuel et sur votre appareil menager. Assurez-vous toujours lire tousles messages de securite et de vous y conformer. de Ce symbole d'alerte de securite vous signale les dangers potentiels de deces et de blessures graves & vous eta d'autres. Voici le symbole d'alerte de securite.
IIVIPORTANTES iNSTRUCTiONS DE SECURITE AVERTISSEMENT : POUR MINIMISER LE RISQUE D'UN FEU DE GRAISSE SUR LA CUISINIERE : AVERTISSEMENT : POUR REDUIRE LE RISQUE DqNCENDE, CHOC ELECTRIQUE OU DOMMAGES CORPORELS, RESPECTER LES INSTRUCTIONS SUWANTES : m Utiliser cet appareiI uniquement dans Ies applications envisag_es par Ie fabricant. Pour toute question, contacter Jefabricant.
EXIGENCESD'XNSTALLATION _Y Rassembbr bs outils et pi_ces necessaires avant de commencer PinstalIation. Lire et suivre bs instructions de s_curite fournies avec bs outib indiques icL Outillage requis niveau : compas ou gabarit circulaire de 8" (20,3 cm) tournevis Phillips pince cisaiIb de ferblantier scie a chantourner sauteuse Une prise de courant electrique reliee a la terre est necessaire. Voir la section "Specifications 6bctriques".
i'!_ i?_i:iii, _:!! i ii!_ii_i _;" _i:i _ii_ii_!,;;_iiii!_ ii,_?_i_ i:i_i_ _i,i:! i!_;J _?!, :!i; [] Le syst_me de d6charge (si necessaire) pour I'installation n'est pas fourni. [] Le syst_me doit decharger I'air a I'exterieur. [] Ne pas terminer le conduit d'evacuation dans un autre espace ferm& Si Ies codes le permettent et si on utilise un conducteur distinct de liaison a Ia terre, il est recommand_ qu'un electricien qualifie verifie Ia qualit6 de Ia liaison a Ia terre.
Ca_cu_ de _a_ongueureffectivedu syst_me ded@cha_ge Syst@me de d@charge de 7" (17,8 cm} Raccords standard recommandes PourcatcuIer laIo;qgueur effective dusyst6me dedecharge, on doitte;qir compte deiaiongueur equivale;qte dechaque composant dusyst_me. Pourlar6alisatio;q ducircuitd'6vacuatio;q, utiliser duconduitde 31/4 '' x 10"(8,3x25,4cm)ou7"(17,8cm);IaIo;qgueur effective maximale ;qedoitpasdepasser 65pi(19,8m).Pourlameilieure performance, ;qepasutiliser plusdetroiscoudes a 90°.
iNSTRUCTiONSD'INSTALLATION D_charge par conduit vertical, diam_tre 7" {17,8 cm} ii}_ii_i ¸¸,i!}!_ !ii ;i_il/it ¸¸¸iili _i:: ii_i _i: i_, i_i i_:_i! _il}_, iil _!i!_ ii_S ii_ ii_ii!i ill! _::e ii_S_S_ ,i}i_i ii_ i; 1. Si possible, deconnecter la cuisini_re (cuisini_re autonome ou encastr_e) et la retirer de I'espace d'instNiation pour pouvoir acceder plus facilement aux placards muraux ou au mur arriere.
2, Entever Ies rubans adh_sifs qui maintiennent les filtres standard en place. Enlever Ies deux filtres. Ins@er un tournevis a lame plate dans I'encoche du filtre. Pousser le fiJtre vers I'arri@e de Ia hotte, soulever )our enlever Ie filtre et conserver Jefiltre a part. Installation avec d_charge _ I'ext@ieur 1. Oter les cinq vis fixant en place le panneau du luminalre; conserver Ies vis. 2. D_brancher Ie connecteur du c_blage du luminaire. Veiller a ne deconnecter aucun conducteur. S.
7. Reinstaller lediffuseur d'air. 8. Rebrancher leconnecteur decAbtage duluminaire et r_instaJler lepanneau duIuminaire. NOTE:Veiller &nepascoincer lesconducteurs entrele support etlepanneau duIuminaire. 9. Enlever I'opercule attachable rectangulaire, dusommet oude I'arriere. SiPairdolt_tre6vacu_ parunconduit roodde7" (17,8cm),enIever !'opercule attachable rectangulaire au sommet ainsiqueI'opercule arrachabJe endemi-cercle. Raccordement direct Risque de choc electrique ___ .... Deconoecter m"entretien.
4, Utiliser desconnecteurs deillsetraccorder ensemble les conducteurs noirs. 5, Utiliser desconnecteurs deillsetraccorder ensemble les conducteurs btancs. 6, Raccorder leconducteur deliaison a laterreducable d'alimentation auconnecteur vertdeliaison alaterre;bien serreL 3, Positionner Ies trous allonges de Ia hotte par-dessus Ia t_te des vis, puis pousser la hotte vers Ie mur pour engager la pattie etroite des trous sur Ies vis de fixation. .... A A, Trous al/ong_s (4) A.
UTXLXSATION DE LA HOTTEDE CUISINIERE ENTRETIENDE LA HOTTEDE CUISINIERE 1: Tableau de eommande Q de Ja hotte A Avant d'entreprendre Ie nettoyage de la hotte, attendre le refroidissement des Iampes. Nettoyage 1. 2. A. Commutateurdu vend/ateur B, Commutateurd'_clairage Fonctionnement du ventilateur Le ventilateur est command_ par un commutateur a bascule 3 positions.
DEMANDED'ASSISTANCEOU DE SERVICE $i vous avez besoin au Canada d'assistance ou de service Pour des questions relatives aux produits, veuillez appeler sans frais Ie Centre d'interaction avec Ia client@e de Whirlpool Canada LR au 1-800=461-5681o Du Iundi au vendredi de 8 h 00 a 18 h 00 (HNE). Le samedi de 8 h 30 a 16 h 30 (HNE). Nos consultants [] [] fournissent de _"assistance pour : Caracteristiques et specifications d'appareils menagers.
GARANTIE DESGROSAPPAREILSMENAGERS WHIRLPOOLCORPORATION GARANTIE LIMITC:E DE UN AN Pendant un an & compter de la date d'achat, Iorsque ce gros appareil menager est utilise et entretenu conformement aux instructions jointes a ou fournies avec le produit, Whirlpool Corporation ou Whirlpool Canada LP (ci-apr_s designees "Whirlpool") paiera pour les pieces de rechange FSP_ et la main-d'oeuvre pour corriger les vices de materiaux ou de fabrication.