ICE MAKER Model 50 ave Ovens, Compactors, Room Air Conditioners, Dehumidifiers, Automatic Washers, Clothes Dryers, Freezers, Refrigerator-Freezers, Ice Makers,Oishwasl
Changing the bin door panel The storage bin door is designed to accept an optional decorative wood panel of your choice. The wood panel should be no more than l/4 inch (6 mm) thick. Cut it to the same size as the production metal panel. See Figure 1. To change the panel: 1. Open the bin door. 2. Remove the two screws on top of the door which hold the handle. 3. Remove the handle and pocket.
4. Remove all tape and packaging material from the outside and inside of the cabinet. See Figure 4. 5. Remove the front grill; take out the screws securing the grill at the bottom and lift it free of cabinet. 2. Area should be well ventilated with temperature above 55OF and below 1 lOOF. Best results are obtained between 7OOF and 9OOF. 3. Provision for electricity, water and drain connections should be determined. 6. Turn the fan by hand to make certain it moves freely. 7.
RIGHT 3/4*-j I-- END VIEW BACK -17.7/w-c 23.7W~. f-l I 1 WATER INLET SOLENOID ‘E ’ t VALVE \ 4” LONG 5/S” I.D. RUBBER: DRAIN TUBE - RUN TO OPEN DRAIN a cy11 7,1/z-“\----_3-3’4” i-1 L L --BEND FIELD TO CONNECT FIGURE 5 ; VIEW 1 HOLE FOR FIELD SUPPIED WATER SUPPilED WATER LINE TO WATER VALVE FITTING l-l/Z” Connect the drain ORDER CONDENSATE PUMP KIT NO. EKDPl FROM YOUR WHIRLPOOL DEALER (observe local codes) 1. The unit is provided with a gravity drain. 2.
Alternate grounding method REMOVE SHUNT DO NOT, UNDER ANY CIRCUMSTANCES, REMOVE THE POWER SUPPLY CORD GROUND PRONG. PLUG IN CONDENSATE PUMP FIG. 5C c For the electrician Electrical requirements A 115 Volt, 60 Hz, AC only, 15 Amp fused electrical supply is required (time delay fuse or circuit breaker is recommended). It is recommended that a separate circuit, serving only this appliance, be provided. DO NOT use an extension cord. ELECTRICAL APPLIANCE.
How it works As the room and water temperatures vary, so will the amount of ice produced. This means that higher operating temperatures will result in reduced ice production.
Unit wiring diagram CUBELET This model operates at 115 volts except for the cutter grid circuit which operates at 8.5 volts at 1 amp. CUTTER GRIDS I- The compressor runs at all times except when the bin thermostat becomes satisfied and opens up. This deenergizes the system except for the transformer and cutter grid.
Makincyour In the event your the appliance or telephone directory name and number (800) 253-1301. Dial just as you nearest Whirlpool this same number in your Use and Learn the WHIRLPOOL Part No. 758876 world a little easier. WHIRLPOOL appliance should need service. call the dealer from whom you purchased service company. Ha is in the Yellow Pages of your a WHIRLPOOL franchised TECH-CARE@ listed under “Appliances-Household-Major-Service and Repair.