AUTOMATIC WASHER ~o=~aP~c~ty LA7680XM and LA7685XM * wave Ovens, Trash Compactors, Room Air Condltloners, Dehumldllvxs. -i Automatic Washers. Clothes Dryers. Freezers.
Parts and features LOAD LAUNDRY INFORMATION TEMPERATURE SELECTOR / MAGIC CLEAN’ LINT FILTER (not shown) CYCLE CONTROL KNOB FABRIC SOFTENER MODEL AND SERIAL NUMBER PLATE (not shown) AGITATOR Remove the Consumer Buy Guide label. It will be easier to remove before the washer is used. You should wipe out the Copy your Model and Serial Numbers When you need service or call with a question, have this information ready: 1. Complete Model and Serial Numbers (from plate under the lid near the hinge]. 2.
Your responsibilities Read this “Use and Care Guide” and your “Laundry Guide” carefully for important use and safety information. You are personally responsible for making sure that your washer.. l is installed by a qualifiedinstaller. l is properly installed and leveled on a floor that can support the weight.* l is connected to the right kind of outlet, electric supply, water supply and drain.’ l is properly grounded.* is used only for fobs normally expected of home automatic washers.
c+~w+:lr~ your Before starting your washer: 1. Measure and add detergent. 2. Place sorted load in washer. 3. Start washer. Select a 1. LOAD SIZE l l l To change the setting on the LOAD SIZE SELECTOR, turn the knob to RESET. Then turn the knob to point at a setting that describes the size of the load you want to wash. Set the knob anywhere on or between HAND WASHABLE (a few small items] and EX LARGE [a full load). See your “Laundry on load sizes. -; r- 2.
3. Start the washer A. Push in the Control Knob and turn it to the right. It must be pushed in and turned only clockwrse B. C. Start the washer by pulling out the Control Knob. The washer will fill to the level you set with wash water of the selected temperature. After filling, the washer will agitate for the selected number of minutes D. Stop on a number in the cycle you want The numbers are minutes of wash time.
What happens in each cycle Each cycle has different agitation and spin speeds designed for different kinds of fabrics. Numbers on the dial in each cycle are the minutes of WASH agitation time. When the Cycle Control Knob is set to a number and pulled outthe washer fills before agitation and timing start. After agitation starts, the knob turns REGULAR HEAVY Cycle High agitation and spin speeds help remove heavy soils and spin water from heavy or sturdy cotton fabrics.
clockwise until it points to OFF and the cycle ends. NOTE:You may hear the sound of water spraying some cycles. In some cycles, cold water is sprayed help with the rinsing. during the spin parts of on the spinning load to NOTE: Always use cold rinse water permanent press fabrics. Special care is needed when soaking or pm-washing See your “Laundry Guide” for proper use of this cycle. for laundry.
Other operating instructions For a rinse and spin For a drain and spin You may need an extra rinse and spin for heavily soiled loads which need more detergent. (Extra detergent can require an extra rinse.) l Push Control Knob in. l Turn clockwise to any.on the dial. See above drawing. l Pull Control Knob out. l The washer will fill to selected level with cold water, agitate 2 minutes, drain and spin. Your washer can be set to drain and spin out water. l Push Control Knob in.
Liquid bleach dispenser Always measure bleach. Do not guess. Follow directions on the bottle for the amount to use. Never use more than 1 cup (250 ml) for a full load. Use less with lower water level settings. Use a cup with a pouring spout to avoid spilling. . Load the washer first . Pour measured bleach carefully into dispenser. DO NOT let bleach splash, drip or run down into the washer basket. Undiluted bleach will damage any fabric. . Start the washer.
For Model LA7685XM Only The SUDS-MISER” System Your washer has the SUDS-MISER@ System. It h&s two drain hoses. One hose moves a portion of used wash water into a storage tub and moves it back into the washer for use during the next wash. The other hose carries water to another tub with an open drain, or to a standpipe drain. If you do not want to re-use wash water for a load, leave the stopper out of the storage tub so the water drains away. . i a portion of the wash water.
Caring for your washer WHEN NOT WASHING, keep both water faucets turned off. This takes the pressure off the water inlet valve and hoses. AFTER WASHING, use a soft dry cloth to wipe the outside and inside dry. Leave the lid up until the basket is dl Wipe up spills right away. Spills can dull or damage the finish. REMOVE SHARP OBJECTS such as pins, buckles, etc., from clothes before washing. Close metal zippers. SHARP OR HEAVY OBJECTS should never be put on or in the washer.
WINTERIZING Because some water stays in the washer, freezrng can cause a lot of damage. If your washer is stored or moved during the cold weather... 1. Shut off both water faucets. Drsconnect and dram water inlet hoses. 2. Put a quart of automobile-type antifreeze in the basket 3. Set the washer for a DRAIN and SPIN [see page 8). Let it run for about 30 seconds to mix the antifreeze and water. ON - To use the washer again.. . 1. Flush water pipes and hoses. 2. Connect hoses to the washer. 3.
If you need service or assistance, we suggest you follow these four steps: 1. Before calling for assistance.. . Performance problems often result from little things you can find and fix yourself without tools of any kind.
2. If you need assistance*... 4. If you have a problem*. Call Whirlpool COOL-LINE@ service assistance telephone number. Dial free tram: Continental U.S. . (BOO) 253-1301 Michigan . . . . . . . (BOO) 632-2243 Alaska 81 Hawaii (BOO) 253-1121 Call our COOL-LINE service assistance telephone number (see Step 2) and talk with one of our Consultants, or if you prefer, write to: Mr.
Notes
whirlpol : Home .i /Appliances Making your world a llttle easier. Part No. 385039 Rev. A cl984 Whirlpool Corporation Printed in U.S.A.
