Installation manual

- 30 -
Error codes
Error code 3: GENRA HOT
Generator too hot (Generator thermoswitch has tripped. Reconnect
by pressing button under oven.)
Error code 4: OVEN HOT
Oven too hot (Oven chamber thermoswitch has tripped. Reconnect
by pressing button under oven.)
Error code 5: FAN HOT
Fan too hot (Thermoswitch in motor has tripped. Wait for 10
minutes and try again.
Error code 6: DRAIN > 75
Drain too hot (Drain temperature has been above 75°C for more
than 5 min. Check that jet in drain is working.)
Error code 7: OVEN SENS
Oven sensor defective (Temperature sensor in oven chamber not
working properly.)
Error code 8: PROBE SENS
Core temp. probe not connected (A program using core temp.
probe has been selected but probe has not been connected.)
Error code 9: GENER SENS
Generator sensor defective (Temperature sensor in generator not
working.)
Error code 10: DRAIN SENS
Drain sensor defective (Sensor in drain not working. Oven can still
be used.)
Error code 11: WATER SHOR
Water shortage (Steam generator was not filled within two minutes.
Check that the water has been turned on.)
Error code 12: SSR HOT SSR too hot (Solid-state relay too hot.)
Error code 13: GENER > 130
Generator too hot (Temperature in steam generator higher than
130°C. If fault recurs, descale generator)
Error code 14: FAN SPEED Fan running too slow
Error code 15: CPU HOT CPU board too hot (> 60°C)
Error code 16: IO BRD HOT IO board too hot (> 60°C)
Error code 18: DATA ERROR Error in set-up data
Error code 19: WRONG LANG Wrong language
Error code 20: NO COM IO
Internal defect (Failure in communication between computer and IO
board.)
Error code 22: NO RESTART Restart not possible (Oven has been without power too long.)
Error code 23: OVEN WARM Oven too hot at CombiWash start-up
Error code 24: DRAIN ERR
Draining failure (Drain blocked or failure of drain pump. Water level
in generator still high after 10 seconds of draining.)
Error code 25: PROBE ERR
Core temperature probe defective (1, 2 or 3 of the elements in
the core temperature probe defective.)
Error code 28: ALARM ERR Configuration error in main alarms (3, 4, 5, 12) (warning)
Error code 29: DOOR SENS Wrong door sensor signal (warning)
Error code 34: WATER PRES Water pressure too low (Check that water is turned on.)
Error code 40: IO BRD HOT Temperature in IO board critical (Warning after program run.)
Error code 43: WRONG SW Wrong software version (Visual Cooking I oven)
Error code 44: DAMPER ERR Failure during initialisation of exhaust at oven start-up
Error code 45: 24 V ERROR 24 V missing or failure of main contactor output