Appliances TWOANDTHREESPEED AUTOMATIC WASHERS For questions about features, operation/performance, parts, accessories or service call: 1-800-253-1301 In Canada, for assistance call: 1-800-461-5681, for installation and service call: 1-800-807-8777 or visit our website at www.whirfpool.com or www.whirfpool.oom/canada Table of Contents ................................................................ 3955154 LSQH41,G8_lI_SQN1! LSQ_H_S_.
TABLE OFCONTENTS WASHER SAFETY ...................................................................... 3 PARTS AND FEATURES ............................................................ 4 WASHER USE ............................................................................. Understanding Washer Cycles .................................................... Loading ......................................................................................... Normal Washer Sounds .................................
W BFJ Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety will follow the safety alert symbol and either the word "DANGER" or This is themessages safety alert symbol. "WARNING." These words mean: You can be killed or seriously injured if you don't immediately follow instructions.
PARTSANDFEATURES This manual covers several different models. The washer you have purchased may have some or all of the parts and features listed below. 1, 2. Control panel Model and serial number label 7. 8. 3. Liquid fabric softener dispenser 4. 5. XTRA ROLL ACTION Lid Other features your washer may have ACCUWASH TM temperature control system 6.
WASHERUSE Understanding Washer Cycles When the Cycle Control knob is set to a number and pulled out, the washer fills (to the selected load size) before agitation and timing start. The washer begins agitating immediately after filling; agitation occurs with the washer lid up or down. During agitation, the agitator creates a continuous reliever action (on some models) that provides a thorough cleaning of the wash load.
2. (OPTIONAL STEP) Pour measured liquid fabric softener into the liquid fabric softener dispenser. Softener is added automatically during the rinse portion of the cycle. StartingYour Washer Dilute liquid fabric softener by filling the dispenser with warm water until liquid reaches the crossbar in the opening. Fire Hazard Never place items in the washer that are dampened with gasoline or other flammable fluids.
anywashcycleand/or asignaltoalertyouwhentoaddliquid chlorine blench toyourwashload. • The end of Cycle Signal is helpful when you are washing items that should be removed from the washer as soon as the cycle ends. • The Bleach Signal alerts you when to add liquid chlorine bleach to your wash cycle after your detergent has had time to work. See "Adding liquid chlodne bleach." Using the CYCLE/BLEACH SIGNAL 8. • Set the selector to OFF/OFF if you do not desire an end of Cycle Signal or a Bleach Signal.
Delicates cycle This cycle features low-speed agitation for gentle soil removal from delicate items and washable knits. Low spin speeds minimize wrinkling. Use this cycle to clean lightly to moderately soiled loads. Hand Washables cycle This cycle features a series of brief, low speed agitations and short soaks to gently clean special-care items. Low spin speeds minimize wrinkling. Wash small loads. If items appear to be floating (due to trapped air), stop the washer by pushing in the Cycle Control knob.
• TROUBLESHOOTING Wasi'mr continues to fill or drsln, orthe cycle seems stuck Rrst try the solutions suggested here and possibly avoid the cost of a service cell... m Is the top of drain hose lower than the water level in washer? The top of the hose must be higher than the water level in the washer for proper operation. See the Installation Instructions. e Does the drain hose fit too tightly in the standpipe, or is it taped to the standpipe? The drain hose should be loose yet fit securely.
Ag_atorogeraUon • The top of the agitator is loose, or moves direction. This is normal. Load is wfinlded in only one • Did you unload the washer promptly? Unload the washer as soon as it stops. • Did you use the right cycle for the load being washed? Use the Casual/Permanent Press cycle or another cycle with low spin speeds (if available) to reduce wrinkling, • Did you overload the washer? The wash load must be balanced and not overloaded. Loads should move fTeely during washing.
ASSISTANCE ORSERVICE Before calling for assistance or service, please check "Troubleshooting." It may save you the cost of a service call. If you still need help, follow the instructions below. When calling, please know the purchese date and the complete model and serial number of your appliance. This information will help us to better respond to your request. If you need replacement parts If you need to order replacement parts, we recommend that you only use FSP_ factory specified parts.
WHmLPOOL ®WASHERWARRANTY ONE-YEAR FULL WARRANTY For one year from the date of purchase, when this washer is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation will pay for FSP" replacement parts and repair labor to correct defects in materials or workmanship. Service must be provided by a Whirlpool designated service company.
