Service manual

Recessed and closet
installation instructions
I
Fire Hazard
l It is recommended that the dryer
be exhausted outside. Failure to
do so may result in the risk of tire.
l If washer/dryer is installed in a
closet, the dryer MUST be
exhausted outside. Failure to do
so may cause a fire.
This washer/dryer may be installed in
a recessed area ar clasd.
The installation spacing l.s In inches and
Is minimum allowable.
Additional spacing should be
considered for ease of Installation,
servicing and compliance with local
codes and ordinances.
If closet door is installed, the
minimum unobstructed air openings
in top’ond bottom is required,
Louvered doors with equivalent air
openings are acceptable.
Closet
installation must be exhausted.
Other installations must use the
minimum dimensions indicated.
To prevent large amounts of lint and
moisture from accumulating and to
maintain drying efficiency, this
appliance should be exhausted
outdoors.
Port No 3389584 Rev C
0 19po WhIrlpool Corporomn
-.
Recessed, nonexhausted installation
must use only the rear exhaust
position and Exhaust Deflector Part
NO. 694609.
3
B
f
SideWow
Rocossed mea mlnlnwm tnrtdatton spoclng.
Note: tt recessed Instatlalion Is exhausted t0
the side or rear. 6’ must be availabl? above
~gbyashor/dryer bul all other spactng can
Front Vtew
A
24 sq In.
f
-
T&f1 01
2
COPPauATlON
Prepared by Whirlpool Corporation. Benton Harbor. Mlchlgon 49022
Product dimensions
28
LLi
48’
-‘\
i+5
+27-3/C
36.
-TM
20-l/2
Dmtn
Punted In U S A