Instruction for Use

ARISTON DISHWASHER - Instructions for installation and use 15
D
ISHWASHER
You have loaded your dishes and you now have to set the
wash cycle. It takes just one minute to learn how
Starting the dishwasher
Ready, steady, go!
You can cancel the
wash cycle in
progress, if it has
only just started.
Make sure the wash
cycle has ended
before removing the
dishes!
If opening the door
soon after the end of
the programme,or
during it, stand away
from the Dishwasher,
to avoid possible
injury from hot
steam.
First of all.
After performing all the operations
described in the previous
paragraphs, turn the water tap on
completely and press ON-OFF
button "A": you will hear a short
beep and indicator light "B" lights
up. Now the appliance is on and
ready to be programmed.
Selecting the wash
cycle.
To select the wash cycle, turn the
cycle selector knob "D" clockwise
until the reference notch on the
knob corresponds with the number
or symbol for the cycle you wish
to set (consult the wash cycle
table on page 17, especially when
first using the appliance).
If the appliance door is shut,
press the Start button "R" and you
will hear a beep; the cycle will
start up within a few seconds.
During this time, you can modify
your choice of wash cycle. A short
beep will indicate the start of the
wash cycle and indicator light "G"
corresponding to the cycle starting
phase will light up.
The dishwasher keeps
you informed.
Your dishwasher is fitted with
indicator lights (G) which light up
to indicate the cycle phase under
way.
Here are the symbols correspond-
ing to each cycle phase:
pre-wash, wash, rinses, drying.
At all times, your dishwasher tells
you which cycle phase is under
way.
Modifying a wash cycle
in progress.
But if you have chosen the wrong
cycle, not to worry! You can cancel
the wash cycle in progress, if it has
only just started.
To modify a wash cycle, keep the
RESET button "R" pressed for
about 5 seconds: a prolonged beep
will sound, followed by three short
beeps. Indicator light "G" will turn
off and at this point, all the settings
will have been cancelled.
To select a new wash cycle,
repeat the operations illustrated
in the paragraph entitled "starting
and selecting the cycle".
You are now free to re-set the
correct wash cycle.
You've left out a dish?
Well, it happens to everyone.
Interrupt the wash cycle by
pressing the ON-OFF button,
insert the dish you had forgotten
and press the ON-OFF button
again. The cycle will start up from
where you interrupted it.
Finished?
The end of the wash cycle is
indicated by two short beeps and
the flashing of the drying phase
indicator light.
Turn off the water tap.
Wait a few minutes before
unloading the dishes: if you wait
a little while, they dry better thanks
to the steam.
Empty the lower rack first.
There's been a power
failure? Have you
opened the dishwasher
door?
The wash cycle stops and then
restarts when the electricity
comes back on or when you
shut the door. Everything is
under control!
Do you want extra
drying?
Press button "E" before you start
the selected wash cycle.
A prolonged beep will inform you
that you have selected extra drying,
a short beep indicates it has been
disabled.
With extra drying, the wash cycle
will last longer, to provide you with
drier dishes.
Warning:
Turn the appliance off by pressing
button A, unplug the appliance
from the electricity socket to cut
off the power supply; the power
supply cable should
consequently be easily
accessible.