Instruction for Use

20 ARISTON DISHWASHER - Instructions for installation and use
D
ISHWASHER
Safety within your home
Your dishwasher was built in accordance with the strictest international safety regulations. They protect you and your family.
Read the instructions and information contained in this manual: they will provide you with useful hints as to installation, use and
maintenance safety. To avoid nasty surprises.
1. Dispose of the packaging
material carefully (follow the
instructions on how to divide
your rubbish up provided by
your local Council)
2. After removing the
packaging, check to make
sure your appliance is intact.
If in doubt, contact a qualified
professional.
3. Your dishwasher must only be
used by adults and for washing
household dishes, according to
the instructions included in
this manual. Do not touch the
appliance with wet hands or
feet or barefoot.
4. We discourage the use of
extension leads and multiple
plugs. If the electricity supply
wire is not long enough, then
have it replaced with one of
the correct length and
remember that it should be
free of bends or dangerous
kinks.
5. If the appliance is not operating
properly or if maintenance
operations are necessary,
disconnect the dishwasher
from the mains power supply
(unplug it!).
6. Keep children away from the
dishwasher when it is open and
keep detergents out of their
reach.
7. Your dishwasher is not to be
installed outdoors, not even if
the area is covered by a roof:
it is extremely dangerous to
leave it exposed to rain and
thunderstorms.
8. Do not touch the heating
element during or straight
after a wash cycle.
9. Do not lean or sit on the door
when it is open, as this could
overturn the dishwasher.
10. If the appliance malfunctions,
turn off the water inlet tap and
disconnect the plug from the
wall socket. Then try
consulting the section entitled
"I you have a problem, read
this". If you cannot resolve the
problem, then call the service
centre.
11. Once taken out of use,
appliances must be made
inoperable: cut the power
supply wire and damage the
door lock.
12. Disposal of old electrical
appliances
The European Directive 2002/
96/EC on Waste Electrical and
Electronic Equipment
(WEEE), requires that old
household electrical
appliances must not be
disposed of in the normal
unsorted municipal waste
stream. Old appliances must
be collected separately in
order to optimise the recovery
and recycling of the materials
If you have a problem, read this
Your dishwasher may not work or not function properly. In many cases, these are problems which can be solved without having to call for
a technician. Before calling the service centre, always check the points below.
The dishwasher won't
start
■ Is the water supply tap
turned on?
■ Is the water supply tap
connected to the hose
properly?
■ Has the water in your home
been cut off?
■ Is the pressure of the water
supply sufficient?
■ Is the hose bent?
■ Is the filter on the water
supply hose blocked?
■ Is the dishwasher door
open?
The dishes are not
clean.
■ Have you put the right
amount of detergent into the
dispenser?
■ Is the wash cycle suitable for
the dishes you have placed
inside the appliance?
■ Are the filter and microfilter
clean?
■ Can the sprayer arms turn
freely?
The dishwasher won't
drain.
■ Is the drain hose bent?
Limescale deposits or a
white film form on the
dishes.
■ Is the lid on the salt
container closed properly?
■ Is the rinse aid dosage
correct?
Error messages.
Your dishwasher is equipped
with a safety system which is
able to detect any operating
anomalies. These anomalies
are reported by one or two
wash cycle indicator lights "G"
flashing rapidly.
Take a note of which lights are
flashing, turn the appliance off
and call for technical assist-
ance.
Tap off alarm
If you have forgotten to turn the
water tap on, your appliance
will remind you of this by
sounding a few short beeps for
a few minutes. Turn the tap on and
your appliance will start up again
after a few minutes. Were you to
be absent when these beeps are
sounded, the appliance will be
blocked automatically and
indicator lights 2 and 3 (wash and
rinses) will flash rapidly. Turn the
appliance off at the ON-OFF but-
ton, turn on the water tap and wait
approximately 20 seconds before
turning the appliance back on. Re-
select a wash cycle as indicated in
the "Selecting the wash cycle"
paragraph and the appliance will
start.
Clogged filter alarm
If the appliance is blocked and
indicator lights 1 (pre-wash)
and 3 (rinses) flash rapidly, this
means the filter is clogged by
large particles of food residue.
Turn the appliance off, clean
the filter thoroughly and repo-
sition it in its seat as illustrated
on page 21. Then turn it back
on. The selected wash cycle will
start up again.
Troubleshooting
Water load solenoid valve
malfunction alarm.
If indicator light 2 (wash) flashes
rapidly, TURN the dishwasher OFF
AND BACK ON AGAIN after one
minute. If the alarm persists, first
turn off the water tap to avoid any
flooding and then cut off the
electricity supply and call for
technical assistance.
You have checked
everything, but the
dishwasher still doesn't
work and the problem
persists?
Call an authorised service centre
near you and remember to mention:
 the type of malfunction
 the model mark (Mod.) and the
serial number (S/N.) indicated on
the rating plate located on the inner
door, to one side.
Never call upon
the services of
unauthorised
technicians and
always refuse
spare parts that
are not originals.
they contain and reduce the
impact on human health and
the environment. The crossed
out "wheeled bin" symbol on
the product reminds you of
your obligation, that when you
dispose of the appliance it
must be separately collected.
Consumers should contact
their local authority or retailer
for information concerning
the correct disposal of their
old appliance.