Microwave Oven Use & Care Guide MW8600XS

Building in your microwave oven
Your microwave oven is not limited to carts, counters or tables Custom installations are made
easy with kits available from your dealer.
1.
Build the microwave oven into a cabrnet or
Ask your dealer for details on...
wall by itself or over built-in single ovens in the
l
832987 -30-inch Built-in Kit
Whirlpool RDE, REE, RGE, RB and SB model series
l
832989 - 24-inch Built-in Kit
2.
Attach the microwave oven to a wall by itself
l
832991 -27-inch Built-in Kit
. 832993 -Wall
Mounting
Kit
or with cabinets over it.
. RH3330XR - MICRO SHELF’ Hood
3. Put the microwave oven on the MICRO SHELF”’
Hood over a cooktop. The hood is available
Use only approved installation kits.
ducted or as a recirculating hood, and includes
Obtain these kits from your authorized
cooktop lights.
Whirlpool dealer.
Caring for your microwave oven
Cleanine the microwave oven
Wipe often with warm sudsy
water and a soft cloth or
sponae.
For stubborn soil, boil a cup
of water in the oven for 2 or 3
minutes. Steam will soften
the so11
CAUTION:
Abrasive
cleansers, steel wool pads, gritty wash cloths,
etc., can damage the control panel, and
the interior
and
exterior oven surfaces. Use a sott cloth or a sponge with a
mild detergent or spmy glass cleaner.
Replacing the light bulb
Be sure to clean the areas
where the door and oven
frame touch when closed.
When cleaning surfaces of
I
door and oven that come to-
gether on closing the door,
use only mild, non-abrasive
soaps or detergents applied
with a sponge or soft cloth.
Rinse well
The microwave oven light should come on whenever the door is opened or the oven is operating.
To replace:
1.
Unplug, or turn off at fuse box or circuit
breaker.
2.
Open the oven door.
3. Remove the 3 screws from the front of the
cover.
4. Pull down the front portion of the cover,
(It is creased across its width to form a hinge.)
5. Remove and replace the 25watt candelabra-
base bulb (Part No. 313969). Obtain bulb from
your authorized Whirlpool dealer.
6.
Close the cover and replace the screws.
7. Plug in, or turn on the main power supply.
23