User Manual

Table Of Contents

REMOVING AND REFITTING THE DOOR

1. To remove the door, open it fully and lower the

catches until they are in the unlock position.

Close the door as much as you can. Take a firm hold

of the door with both hands – do not hold it by the

handle.Simply remove the door by continuing to

close it while pulling it upwards at the same time

until it is released from its seating. Put the door to

one side, resting it on a soft surface.

~15°

3. Refit the door by moving it towards the oven,

aligning the hooks of the hinges with their seating

and securing the upper part onto its seating.

4. Lower the door and then open it fully. Lower the

catches into their original position: Make sure that

you lower them down completely.

Apply gentle pressure to check that the catches are

in the correct position.

“CLICK”

Try closing the door and check to make sure that it

lines up with the control panel. If it does not, repeat

the steps above: The door could become damaged if

it does not work properly.

REPLACING THE LAMP

1. Disconnect the oven from the power supply.

2. Unscrew the cover from the light, replace the bulb

and screw the cover back on the light.

3. Reconnect the oven to the power supply.

Please note: Only use 20-40 W/230 ~ V type G9, T300°C

halogen bulbs. The bulb used in the product is speciÿcally

designed for domestic appliances and is not suitable for

general room lighting within the home (EC Regulation

244/2009). Light bulbs are available from our After-sales

Service.

Do not handle bulbs with your bare hands as your ÿngerprints

could damage them. Do not use the oven until the light cover

has been reÿtted.