Instructions for use WASHER-DRYER GB English,1 This symbol reminds you to read this instruction manual.
Installation GB This instruction manual should be kept in a safe place correctly will provide it with stability, help to avoid vibrations and excessive noise and prevent it from shifting while it is operating. If it is placed on carpet or a rug, adjust the feet in such a way as to allow a sufficient ventilation space underneath the washer-dryer. Read these instructions carefully: they contain vital Connecting the electricity and water supplies for future reference.
Connecting the drain hose 65 - 100 cm Connect the drain hose, without bending it, to a draining duct or a wall drain situated between 65 and 100 cm from the floor; the supply voltage is included within the values i ndicated on the Technical details table (see page 5); GB the socket is compatible with the washing machine's plug. If this is not the case, replace the socket or the plug. Your appliance is now supplied with a 13 amp fused plug it can be plugged into a 13 amp socket for immediate use.
GB As the colours of the wires in the lead may not correspond with the coloured markings identifyng the terminals in your plug, proceed as follows: Connect Green & Yellow wire to terminal marked E or or coloured Green or Green & Yellow. Connect Brown wire to terminal marked L or coloured Red. Connect Blue wire to terminal marked N or coloured Black. If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse, either in the plug or adaptor or at the distribution board.
GB Technical data Model PWDC 8125 W Dimensions width 59,5 cm height 85 cm depth 62 cm Capacity from 1to 8 kg for wash programme from 1 to 6 kg for the drying programme Electrical connections please refer to the technical data plate fixed to the machine Water connections maximum pressure 1 MPa (10 bar) minimum pressure 0.05 MPa (0.
Description of the waher-dryer and starting a wash cycle GB Control panel WASH CYCLE PROGRESS indicator lights INDICATOR LIGHTS ON/OFF button WASH CYCLE Detergent dispenser drawer FUNCTION buttons with indicator lights START/ PAUSE knob button with indicator light TEMPERATURE DOOR LOCKED indicator light button DRY button Detergent dispenser drawer: used to dispense detergents and washing additives (see Detergents and laundry). ON/OFF button: switches the waher-dryer on and off.
Indicator lights Wash The indicator lights provide important information. This is what they can tell you: Rinse Delayed start If the DELAY TIMER function has been activated (see Personalisation), after the wash cycle has been started the indicator light corresponding to the selected delay period will begin to flash: Drying As time passes, the remaining delay will be displayed and the corresponding indicator light will flash: The set programme will start once the selected time delay has expired.
Wash cycles Table of wash cycles Wash cycles GB Description of the wash cycle Detergents Max. temp. (°C) Max. speed (rpm) Drying Main wash Fabric softener Max. load (kg) Cycle duration 90° 1200 • • • 8 164 60° 1200 • • • 8 160 40° 1200 • • 147 1200 • • 8 60° • • 8 144 40° 1200 • • • 8 96 • • • • • • • • 3,5 75 4 60 2 69 2 55 • • • • • • 2 55 3 90 Max. 2 pairs 50 - 40° 800 5 Smart cycles White Cotton: extremely soiled whites.
Personalisation Setting the temperature GB Press the TEMPERATURE button to set the wash temperature (see Table of wash cycles). The temperature may be lowered, or even set to a cold wash . The waher-dryer will automatically prevent you from selecting a temperature which is higher than the maximum. Setting the drying cycle Table of Drying times (guideline values) Note: if all the drying indicator lights remain unlit, the Fabric Load type Max.
Detergents and laundry GB Detergent dispenser drawer Good washing results also depend on the correct dose of detergent: adding too much detergent will not necessarily result in a more efficient wash, and may in fact cause build up on the inside of your appliance and contribute to environmental pollution. Do not use hand washing detergents because these create too much foam. B Open the detergent dispenser drawer and pour in the detergent or washing additive, as follows.
Precautions and tips This washer-dryer was designed and constructed in accordance with international safety regulations. The following information is provided for safety reasons and must therefore be read carefully. Do not use the appliance to dry foam rubber or similar elastomers. Make sure that the water tap is turned on during the drying cycles.
Care and maintenance GB Cutting off the water and electricity supplies Turn off the water tap after every wash cycle. This will limit wear on the hydraulic system inside the waher-dryer and help to prevent leaks. 2. unscrew the lid by rotating it anti-clockwise (see figure): a little water may trickle out. This is perfectly normal; Unplug the waher-dryer when cleaning it and during all maintenance work.
Troubleshooting Your waher-dryer could fail to work. Before contacting the Technical Assistance Centre (see Assistance), make sure that the problem cannot be not solved easily using the following list. Problem: GB Possible causes / Solutions: The waher-dryer does not switch on. The appliance is not plugged into the socket fully, or is not making contact. There is no power in the house. The wash cycle does not start. The waher-dryer door is not closed properly.
Service Before calling for Assistance: Check whether you can solve the problem alone (see Troubleshooting); Restart the programme to check whether the problem has been solved; If this is not the case, contact an authorised Technical Assistance Centre using the telephone number provided on the guarantee certificate. GB Always request the assistance of authorised technicians. Have the following information to hand: the type of problem; the appliance model (Mod.); the serial number (S/N).
Guarantee 12 Months Parts and Labour Guarantee Your appliance has the benefit of our manufacturers guarantee, which covers the cost of breakdown repairs for twelve months from the date of purchase. This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either workmanship or materials, we will, at our discretion, either repair or replace the appliance at no cost to you.
195081645.00 10/2009 - Xerox Fabriano GB After Sales Service No one is better placed to care for your Indesit appliance during the course of its working life than us - the manufacturer. Essential Contact Information Indesit Service We are the largest service team in Europe offering you access to 400 skilled telephone advisors and 1100 fully qualified engineers on call to ensure you receive fast, reliable, local service. UK: 08448 224 224 Republic of Ireland: 0818 313 413 www.indesitservice.co.