User Manual www.aristonchannel.
Quick Guide GB THANK YOU FOR PURCHASING A ARISTON PRODUCT. Before using the appliance carefully read the Health and Safety guide. Before using the machine, it is imperative that the transport bolts are removed. For more detailed instructions on how to remove them, see the Installation Guide. To receive more comprehensive assistance, register the appliance on www.aristonchannel.com/register CONTROL PANEL 1 1. STEAM HYGIENE / MUTE button 2. FINAL CARE / KEY LOCK button 3. ON/OFF button 4.
WASH CYCLES Follow the instructions on the symbols of the garment’s wash care label. The value indicated in the symbol is the maximum recommended temperature for washing the garment. Mixed For washing lightly to normally soiled resilient garments in cotton, linen, synthetic fibres and mixed fibres. Eco Cotton 60°/40° Suitable for washing normally soiled cotton garments.
ADDING GARMENTS An icon on the display will signal when additional garments can be introduced into the washing machine, without decreasing the washing performance. To add garments, first stop the washing machine by pressing the START/PAUSE button then open the door and insert them. Press the START/PAUSE button again to restart the wash cycle from the point at which it was interrupted.
TROUBLESHOOTING Your washing machine could occasionally fail to work. Before contacting the Technical Assistance Service, make sure that the problem cannot be easily solved using the following list. Anomalies Possible causes / Solution The washing machine does not start. The appliance is not plugged into the socket fully, or not enough to make contact. There is no power in the house. The washing machine door is not closed properly. The ON/OFF The wash cycle does not start. button has not been pressed.
CLEANING & MAINTENANCE For any cleaning and maintenance, switch off and unplug the washing machine. Do not use flammable fluids to clean the washing machine. CLEANING THE OUTSIDE OF THE WASHING MACHINE Use a soft damp cloth to clean the outer parts of the washing machine. Do not use glass or general purpose cleaners, scouring powder or similar to clean the control panel – these substances might damage the printing. CHECKING THE WATER SUPPLY HOSE Check the inlet hose regularly for brittleness and cracks.
CLEANING THE DETERGENT DISPENSER Remove the dispenser by raising it and pulling it out (see figure). Wash it under running water; this operation should be repeated frequently. 1 2 CLEANING THE WATER FILTER / DRAINING RESIDUAL WATER Switch off and unplug the washing machine before cleaning the water filter or draining residual water. If you used a hot wash programme, wait until the water has cooled down before draining any water.
TRANSPORT AND HANDLING Never lift the washing machine by holding it at the worktop. 1. Pull out the mains plug, and close the water tap. 2. Make sure that door and detergent dispenser are properly closed. 3. Disconnect the inlet hose from the water tap, and remove the drain hose from your draining point. Remove all rest water from the hoses, and fix them so that they cannot get damaged during transport. 4. Refit the transport bolts.
10 mm - 0,39 inch 3. 2. 1. 150 ml 100 ml 50 ml 4. 2 cm - 0,7 inch 6. 5. 7.
8. 9. max 0,5 cm max 0,2 inch 10. 11. 12. max 100 cm 39 inch min 65 cm 25 inch max 100 cm 39 inch min 65 cm 25 inch max 100 cm 39 inch min 65 cm 25 inch 13. 14.
SAFETY INSTRUCTIONS Before using the appliance, read these safety instructions. Keep them nearby for future reference. These instructions and the appliance itself provide important safety warnings, to be observed at all times. The manufacturer declines any liability for failure to observe these safety instructions, for inappropriate use of the appliance or incorrect setting of controls. Very young children (0-3 years) should be kept away from the appliance.
ELECTRICAL WARNINGS It must be possible to disconnect the appliance from the power supply by unplugging it if plug is accessible, or by a multi-pole switch installed upstream of the socket in accordance with the wiring rules and the appliance must be earthed in conformity with national electrical safety standards. Do not use extension leads, multiple sockets or adapters. The electrical components must not be accessible to the user after installation. Do not use the appliance when you are wet or barefoot.
