Instruction for Use

- 11 -
Maintenance
Clean front panel of Indoor Unit
1. Disconnect from the power supply
Turn o the appliance rst before disconnecting from power supply.
2. Remove the front panel
Open the front panel as shown by the arrow (Fig. A).
Pull the slots at the side of the front panel with force to take out the front
panel (Fig. B).
3. Clean the front panel
Wipe it with a soft and dry cloth. Use lukewarm water (below 40°C) to clean
if the appliance is very dirty. After cleaning let it dry.
4. Ret and close the front panel
Ret and close the front panel by pushing it downward.
Note:
• Do not use substances such as gasoline or polishing powder to clean
the appliance.
• Do not sprinkle water onto the indoor unit Dangerous! Electric shock!
Clean Air lter
It is necessary to clean the air lter after using it for about 200 hours. Clean
the air lter every two weeks if the air conditioner operates in an extremely
dusty environment.
1. Disconnect from the power supply
Turn o the appliance rst before disconnecting from power supply.
2. Take out air lter (Fig. C).
1. Open the front panel. 2. Press the handle of the lter gently. 3. Slide out
the lter.
3. Cleaning the air lter (Fig. D)
If the lter is very dirty, clean it with a solution of lukewarm water and
neutral detergent.
After cleaning let it dry.
4. Ret the lter, press the lter reset button (Fig.E) at right side by using
a cylinder pin and close the front panel.
Note:
• To avoid injury, do not touch the ns of indoor unit with your ngers
after removing the lter.
• Do not attempt to clean the inside of the air conditioner by yourself.
• Do not clean the lter in washing machine.
EMERGENCY OPERATION
Under emergency situation or when remote
control is missing, you can control the unit
by pressing the on/o swith located on the
indoor unit.
• Turn on the appliance: when the unit is o,
press this button, it will start up and operate
in
Smart mode.
• Turn o the appliance: when the unit is on,
press this button, the unit will stop working.
Note: Do not press this button for a long
time as it will cause malfunction.
Auto-Restart Function
If you want to set auto-restart, switch on the power supply, press the ON/OFF button on the indoor unit and hold for
over 5 seconds, auto-restart is set with buzz sound.
If the auto-restart has been set, press the ON/OFF button on the indoor unit and hold for over 5 seconds, auto-restart
function will be cancelled with a buzz sound and air conditioner is on standby mode.
Disposal of the batteries
To protect natural resources and to promote material reuse, please separate batteries from other types of waste and
recycle them through your local, free battery return system.
Fig. A
Fig. B
Filter Reset button
Fig. E
Fig. C
Fig. D
on/o switch
on/o switch