Installation Instruction
11
REMOVE ACCESS PANEL
8. Remove access panel
Using a 1/4" nut driver or Phillips screwdriver, remove the two
screws attaching access panel to dishwasher.
9. Measure cabinet opening
Measure the height of cabinet opening from the underside of
the countertop to the oor where dishwasher will be installed.
Be sure to measure the lowest point on the underside of the
countertop and the highest point on the oor.
10. Leveling leg adjustment
Extend leveling legs out from the dishwasher base, 1/4" less than
the shortest opening height measured in cabinet opening.
Turn leg counter clockwise to raise the dishwasher or clockwise
to lower the diswasher.
CONNECT ELBOW TO VALVE
11. Connect elbow to ll valve
Elbow
Tighten elbow until snug, and be sure that it faces toward
channel in bottom of base.
12. Fill valve location
Fill valve location
CONNECT FILL HOSE TO ELBOW
13. Flexible line
Flexible braided line: Conrm the exible braided line is long
enough.
Attach exible line to elbow then route hose out the bottom left
channel under the dishwasher. Secure in channel with tape or
wire ties.