QUICK REFERENCE GUIDE GB BEFORE USING THE APPLIANCE FOR THE FIRST TIME: • FOLLOW THE “INSTALLATION INSTRUCTIONS”. • REMOVE THE TRANSIT BOLTS BEFORE USING THE APPLIANCE. • First wash cycle without laundry: 1. Turn on the tap. 2. Close the appliance door. . 3. Pour a small amount of detergent (about 30 ml) into the detergent dispenser 4. Select a short program (see programme chart). 5. Press the “On/Off” button.
GB CONTENTS INSTALLATION INSTRUCTIONS PAGE 21 APPLIANCE AND ACCESSORIES PAGE 25 CHILD SAFETY PAGE 25 PROTECTING THE ENVIRONMENT PAGE 26 SAFETY INSTRUCTIONS PAGE 26 TRANSPORT / HANDLING PAGE 26 PREPARING THE WASH PAGE 27 DETERGENT AND ADDITIVES PAGE 28 DYEING AND BLEACHING PAGE 29 PROGRAMME SELECTION / PROGRAMME START PAGE 29 DOOR LOCK/ PROGRAMME END PAGE 30 CHANGING / INTERRUPTING / CLEARING PROGRAMME PAGE 30 REMOVING THE FILTER PAGE 31 DRAINING RESIDUAL WATER PAGE
INSTALLATION INSTRUCTIONS Never move the appliance by carrying it at the worktop. TRANSIT BOLTS The appliance is fitted with transit bolts to prevent internal damage during transport. Before using the machine you must remove the transit bolts (Fig. 1). 1. Slacken the four bolts with the wrench supplied (Fig. 2). 2. Unscrew the bolts by hand. 3. Holding the bolt head, pull each bolt through the wide part of the holes. 4.
INSTALLATION INSTRUCTIONS INSTALLATION • • • Install the appliance on a solid and level floor surface, preferably in a corner of the room. Make sure that all four feet are stable and resting on the floor and then check that the appliance is perfectly level (use a spirit level). If the floor is uneven, adjust the levelling feet as required (do not insert pieces of wood etc. under the feet): 1. Slacken the locknut using the wrench supplied. 2. Adjust the height of the foot, turning it by hand. 3.
INSTALLATION INSTRUCTIONS WATER SUPPLY • • • Water supply: cold water only Tap: 3/4” threaded hose connection Pressure: 100-1000 kPa (1-10 bar). WATER INLET HOSE 1. The dirt strainer (already premounted on the hose end or included in the accessories) must be inserted into the threaded tap coupling. 2. Carefully screw the hose connection onto the tap preferably by hand. Make sure there are no kinks in the hose. 3. Check water-tightness of tap and appliance connections by turning the tap completely on.
INSTALLATION INSTRUCTIONS ELECTRICAL CONNECTIONS • • • • • • • 24 Electrical connections must be made in accordance with local regulations. The appliance must be connected to the mains exclusively by means of a socket with an earth connection in accordance with established regulations. The appliance must be earthed by law. The manufacturer declines all liability for damage to property or injury to persons or animals deriving either directly or indirectly from failure to observe the above directions.
APPLIANCE AND ACCESSORIES 1. 2. 3. 4. 5. 6. Worktop Control panel Detergent dispenser After-Sales Service sticker (on the back side of the door) Door Door handle - To open the door press the button on the inside of the handle and pull - Close the door by pushing it firmly (the lock will click into place) 7. Child safety (inside door) 8. Filter (behind cover) 9. Residual water drain (behind the plinth) 10. Plinth 11.
PROTECTING THE ENVIRONMENT PACKING MAXIMISE THE LOAD SIZE • • • The packing material is 100% recyclable (marked with the recycling symbol ). Adhere to local regulations when disposing of packaging material. The packaging material (plastic bags, polystyrene parts, etc.) is potentially dangerous and must be kept out of reach of children. PRODUCT • • The appliance is made from recyclable materials and must be scrapped in accordance with local waste disposal regulations.
PREPARING THE WASH 1. Sort the laundry according to… • Type of fabric / care label symbol Cottons, mixed fibres, easy care/synthetic, wool, handwashed items. • Colour Separate whites and coloureds. Wash new coloured items separately. • Size Wash items of different sizes in the same load to improve washing efficiency and distribute the load more evenly inside the drum. • Fabric delicacy Wash delicate articles separately: use a special programme for Pure New Wool , curtains and other delicates.
DETERGENT AND ADDITIVES CHOOSING THE RIGHT DETERGENT • The type of detergent depends on: • type of fabric (cottons, easy care/synthetic, delicate items, wool). Note: use only specific detergents for wool. • colour; • washing temperature; • degree and type of soiling. DOSAGE Do not use solvents (turpentine, benzine, etc.). Do not machine wash fabrics that have been treated with solvents or flammable liquids.
DETERGENT AND ADDITIVES Notes: • You can use liquid detergent in the “Prewash” phase for programmes with this option. In this case use only powder detergents for the main wash. • When using concentrated fabric softeners, add water in the detergent dispenser up to “MAX” level mark. • To prevent dispensing problems when using highly concentrated powder and liquid detergents, use the special detergent ball supplied with the detergent and place it inside the drum.
DOOR LOCK/ PROGRAMME END DOOR LOCK PROGRAMME END The door locks automatically after the programme start until the end of the programme. When the programme is finished, the door is released after approximately 1 minute. When the programme is interrupted due to an electricity supply interruption (the pilot lamp is off and perhaps water is inside the drum), the door will be released after approximately 1 minute. In this case do not open the door, because hot water could come out of the door.
REMOVING THE FILTER WHEN SHOULD I REMOVE THE FILTER? Check the filter two or three times a year and clean it if necessary. • Check the filter if the appliance is not draining properly or if it fails to perform spin cycles. • Remove the filter if the pump is blocked by an object (buttons, coins, safety pins, etc.). IMPORTANT: make sure the water has had time to cool before draining the appliance. REMOVING THE FILTER 1. Switch off the appliance and unplug it. 2.
DRAINING RESIDUAL WATER WHEN SHOULD I DRAIN RESIDUAL WATER? • • Before transporting (moving) the machine. If the appliance is installed in a room subject to subzero temperatures. It is best in this case to drain the machine after every wash. DRAINING RESIDUAL WATER The residual water drain hose is located in the appliance plinth. Before draining residual water unplug the machine. 1. Remove carefully the plinth using the thin rounded projection of the coloured insert from the detergent drawer. 2.
CARE AND MAINTENANCE WATER HOSE MESH FILTERS FILTER • Check and clean periodically. For machines with a straight water supply hose (see figure) 1. Turn off the tap. 2. Unscrew the hose from the tap. 3. Clean the internal strainer. 4. Screw the supply hose back onto the tap. 5. Unscrew the hose from the machine. 6. Remove the filter from the washing machine with pliers and clean it. 7. Replace the filter and screw the hose connection back on to the machine. 8.
TROUBLESHOOTING GUIDE Water Stop fault (depending on model) When the appliance identifies a water leakage the pump is running continuously. Switch off the appliance, unplug it and make sure that the water tap is closed. The “Water Stop” may have been triggered by: 1. too much foam: 2. leakage in the inlet hose or in the appliance. Tilt the appliance forwards carefully to allow the collected water to flow out from the bottom of the appliance. Then: 1. connect the appliance to the electrical outlet, 2.
