Use and Care Manual

4
6.Start or Resume a Cycle
NOTE: Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water.
■ If the Start/Resume button is located on top of door; push door
firmly closed within 3 seconds of pressing START/RESUME. If door
is not closed within 3 seconds, the Start/Resume button LED will
flash, an audible tone will be heard, and cycle will not start.
IMPORTANT: If anyone opens the door (such as, for adding a dish,
even during the Delay Hours option), the START/RESUME button must
be pressed each time.
■ If your Start/Resume button is located on front of door: push door
firmly closed. The door latches automatically. Select the wash
cycle, options and press START/RESUME or press
START/RESUME to repeat the same cycle and options as in
previous wash cycle.
This information covers several different models. Your dishwasher may not have all of the cycles and options described.
CYCLES SOIL LEVEL WASH TIME* (MINS.)
W/O OPTIONS
WATER
USAGE
GALLONS
(LITERS)
TYPICAL MAX
Use for hard-to-clean, heavily soiled pots, pans, casseroles, and
tableware.
All soil levels 122 125 7.47 (28.28)
This cycle with only the Heated Dry option selected, and without
other options selected, is recommended to completely wash
and dry a full load of normally soiled dishes. The energy usage
label is based on this cycle and option combination.
All soil levels 88 91 3.01 (11.38)
For fast results, 1-Hr Wash will clean dishes using slightly more
water and energy. Selecting the Heat Dry option will increase
total cycle time but dry dishes faster than air drying alone.
All soil levels 59 62 5.80 (21.94)
CYCLE GUIDE
OPTIONS CAN BE
SELECTED
WITH
WHAT IT DOES ADDED TIME TO CYCLE ADDED
WATER
GALLONS
(LITERS)
TYPICAL MAX
Raises main wash temperature to improve
cleaning for loads containing tough, baked-
on food.
Heavy
Normal
Increases the
temperature of the
main wash and
increases the water
used in prewash and
rinses, improving
wash performance.
23 25 2.79 (10.56)
Dries dishes with heat. Plastic items are less
likely to deform when loaded in the top rack.
Turn the Heat Dry option off for air dry.
Available
with any
cycle
Turns on the heat
element at the end of
the wash cycle for
better dry
performance.
49 49 0
Control Purpose Comments
Press to start or
resume a wash
cycle.
If the door is opened during a cycle or the power is interrupted, the Start/Resume button LED flashes. Cycle
will not resume until door is closed and START/RESUME is pressed.
NOTE: If Start/Resume button is located on top of door, push door firmly closed within 3 seconds of pressing
START/RESUME. If door is not closed within 3 seconds, Start/Resume button LED will flash, an audible tone
will be heard (on some top control models), and cycle will not start.
Press to cancel
wash cycle.
Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let dishwasher drain completely.
To follow progress
of your
dishwasher cycle.
The Clean indicator glows when a cycle is finished.