Service Manual
Table Of Contents
- W11187658-18" & 24" ADA Models Built-In Dishwashers
- Table of Contents
- Section 1: General Information
- Section 2: Diagnostics & Troubleshooting
- Section 3: Testing
- Section 4: Component Access
- Removing the Tub Gasket and Trim
- Removing the Outer Door Panel
- Removing the Control Panel
- Removing Door Switch Assembly
- Removing Dispenser Assembly
- Replacing the Inner Door Panel
- Removing the Air Breaker Assembly
- Removing the Nozzle Duct
- Removing the Control Board
- Removing the Water Valve
- Under Tub Components
- Removing the Pressure Switch
- Removing the Drain Pump
- Removing the Thermistor & Turbidity Sensor
- Removing the Heating Element
- Removing the Wash Pump Assembly
- Removing the Sump Assembly
- Product Specifications & Warranty Information
COMPONENT ACCESS
18” & 24” ADA Built-In Dishwashers
n
4-5
Remove Door Switch Assembly
1. Unplug dishwasher or disconnect power.
2. Disconnect the 2-pin harness from the door switch
assembly on top of the dishwasher (see Figure 1).
Disconnect Harness
Figure 1
3. Using a Phillips screwdriver, remove the two (2) screws
securing the door switch assembly to the cabinet. See
Figure 2.
Remove Screws
Figure 2
4. Remove door switch assembly.
Removing Door Switch Assembly
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.