Service Manual
Table Of Contents
- W11187658-18" & 24" ADA Models Built-In Dishwashers
- Table of Contents
- Section 1: General Information
- Section 2: Diagnostics & Troubleshooting
- Section 3: Testing
- Section 4: Component Access
- Removing the Tub Gasket and Trim
- Removing the Outer Door Panel
- Removing the Control Panel
- Removing Door Switch Assembly
- Removing Dispenser Assembly
- Replacing the Inner Door Panel
- Removing the Air Breaker Assembly
- Removing the Nozzle Duct
- Removing the Control Board
- Removing the Water Valve
- Under Tub Components
- Removing the Pressure Switch
- Removing the Drain Pump
- Removing the Thermistor & Turbidity Sensor
- Removing the Heating Element
- Removing the Wash Pump Assembly
- Removing the Sump Assembly
- Product Specifications & Warranty Information
4-10
n
18” & 24” ADA Built-In Dishwashers
COMPONENT ACCESS
Removing the Control Board
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
Remove the Control Board
The Control Board can be removed from its enclosure at the
boom of the dishwasher.
1. Unplug dishwasher or disconnect power.
2. Remove two (2) screws securing the kick board (toe panel)
to dishwasher frame (see Figure 1).
Figure 1
3. Remove one (1) cover screw from the control board
enclosure (see Figure 2). Remove cover and set aside.
Figure 2
4. Disconnect all harnesses from the control board.
5. Depress the two (2) clips indicated in Figure 3 and remove
control board from enclosure.
Figure 3