Service Manual
Table Of Contents
- W11187658-18" & 24" ADA Models Built-In Dishwashers
- Table of Contents
- Section 1: General Information
- Section 2: Diagnostics & Troubleshooting
- Section 3: Testing
- Section 4: Component Access
- Removing the Tub Gasket and Trim
- Removing the Outer Door Panel
- Removing the Control Panel
- Removing Door Switch Assembly
- Removing Dispenser Assembly
- Replacing the Inner Door Panel
- Removing the Air Breaker Assembly
- Removing the Nozzle Duct
- Removing the Control Board
- Removing the Water Valve
- Under Tub Components
- Removing the Pressure Switch
- Removing the Drain Pump
- Removing the Thermistor & Turbidity Sensor
- Removing the Heating Element
- Removing the Wash Pump Assembly
- Removing the Sump Assembly
- Product Specifications & Warranty Information
COMPONENT ACCESS
18” & 24” ADA Built-In Dishwashers
n
4-13
Removing the Pressure Switch
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
Remove the Pressure Switch
1. Unplug dishwasher or disconnect power.
2. Open the dishwasher door and take out cutlery basket
and lower rack.
3. Remove dishwasher from installaon and lay dishwasher
on its back.
4. Remove the one (1) screw that aaches base cover to the
base. Remove base cover and set aside.
5. Release the snap clip that aaches the pressure switch to
the base. Remove pressure switch from dishwasher.
Pressure Switch
Figure 1
6. Disconnect harness from pressure switch (see Figure 2).
7. Remove the pressure switch hose from the pressure
switch. See Figure 2.
Remove Hose
Disconnect Harness
Figure 2
NOTE: When installing the pressure switch, ensure the switch
is fully seated in the boom of the base bracket.