Service Manual
Table Of Contents
- W11187658-18" & 24" ADA Models Built-In Dishwashers
- Table of Contents
- Section 1: General Information
- Section 2: Diagnostics & Troubleshooting
- Section 3: Testing
- Section 4: Component Access
- Removing the Tub Gasket and Trim
- Removing the Outer Door Panel
- Removing the Control Panel
- Removing Door Switch Assembly
- Removing Dispenser Assembly
- Replacing the Inner Door Panel
- Removing the Air Breaker Assembly
- Removing the Nozzle Duct
- Removing the Control Board
- Removing the Water Valve
- Under Tub Components
- Removing the Pressure Switch
- Removing the Drain Pump
- Removing the Thermistor & Turbidity Sensor
- Removing the Heating Element
- Removing the Wash Pump Assembly
- Removing the Sump Assembly
- Product Specifications & Warranty Information
4-18
n
18” & 24” ADA Built-In Dishwashers
COMPONENT ACCESS
Removing the Sump Assembly
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
Removing the Sump Assembly
Preparation:
Remove the following items from inside the dishwasher (see
Figure 1 below):
1. Cutlery Basket (not shown)
2. Lower Rack (not shown)
3. Lower Spray Arm
4. Cylindrical Filter (1/4 turn counterclockwise)
5. Steel Filter (li out)
6. Lower Spray Seat (see page 4-9)
Figure 1
Lower Spray Arm
Steel Filter
Cylindrical Filter
Connued on next page . . .
Lower Spray Seat
(remove 2 screws)